Installing The Quick Sink Adapter; Before Washing - Premium PWMA231PM Manual De Uso Y Cuidado

Installing the Quick Sink Adapter

When installing the quick sink faucet adapter to the faucet, follow the steps below:
1. First, remove the aerator from your faucet nozzle and determine the size/type of
the faucet.
2. Once you determine the size/type of the faucet (Outside Threaded End or Inside
Threaded End), place the proper sized rubber washer into the silver faucet adapter.
3. Attach the silver faucet connector to the faucet.
4. Attach the faucet connector to the water inlet hose and make sure that the rubber
washer is placed in between.
5. Attach the other end of the water inlet hose to the washer water inlet and make
sure that the rubber washer is placed in between.
Faucet Adapter
Quick Connector
Water inlet hose
Washer
Drain hose
Washers
Faucet
Washer
Rear View of Washer
8

Before Washing

Adjust the adjustable feet to
1
stabilize the washer.
Adjustable feet (extend by rotating
clockwise and shorten by rotating
counterclockwise).
Slightly tilt the washer and loosen the adjustable feet to
make sure all four corners of the washer are steadily in
contact with the floor. Then, tighten the adjustable foot
knob and lock it. If the floor is not completely flat, it
should be corrected before installing the washer to
avoid the washer barrel to incline and knock the cabinet.
Connect to
3 5
power source.
Upper Drain
Note:
Turn on the
4 Water may
overflow if
water supply.
the height
of the water
drain is over
860mm.
Notice: Please remove all coins, keys and any
NOTICE
hard items from all clothes' pockets and zip up
！
clothes before washing to avoid damage to the
clothes and/or the washer barrel.
Install the water
2
inlet hose.
For two inlet hoses.
Put the drain hose Put in the
6
down. clothes to
wash and
detergent.
9