Connecting A Y-Cam To Your Network - Y-cam Cube Guía Inicio Rápida

Connecting a Y-cam to your network

A PC or Mac is required for the initial setup of a Y-cam only and once the camera is
confi gured, a Y-cam can be used independently without being connected to a computer.
Using the Network Cable provided, plug one end in to your router/modem (your local
network), and the other end in to the Y-cam. Connect the power adaptor to the power port
on the Y-cam and the other end in to an electrical socket, and switch on the power.
You must then use a computer connected to this local network to complete the installation.
PC Setup Instructions
Insert the Setup CD-Rom and the Installation screen will appear (if it does not, locate the CD
Drive within Windows and open Autorun.exe). Click "Install Software". This will install Y-cam
Setup which allows you to fi nd your camera on your network. Windows may ask whether you
wish to "Allow" or "Block" the software install. Click "Allow". Then follow the instructions
onscreen. The program will install a shortcut icon on to your desktop. After the installation
fi nishes click "Exit" to close the Installation screen.
Double-click the new Y-cam Setup icon on your desktop to run the program.
The program will search for the camera(s) connected to your local network and display any it
fi nds. Use this program anytime you need to fi nd your camera on your local network -
to view it or to change its settings. Each camera attached and found on your local network
will have an internal IP address assigned to it, and displayed. See Fig.1
Select the camera you wish to connect to and click "Open".
This will open up the cameras Homepage in a new web browser window.
6