Memory; Unit Of Measure (Metric, Feet And Inches); Simple Distance Measurement - Starrett LMXP-100 Manual De Instrucciones

Measurement Reference
For measurements from corners, the STARRETT LMXP-100 allows the front, rear or extender measurement reference to
be selected as follows:
With the instrument turned on, press the
The STARRETT LMXP-100 memorizes the last 20 measurements made. To access them, proceed as follows:
1- Press the
2- To view the desired memory, press the
3- To leave this function, press the
The STARRETT LMXP-100 has automatic conversions for various units (metric, feet and inches). To change this setting
follow the directions below; press the
measurement;
Units
Presentation on
the display
Length
Area
Volume
For simple distance measurements, follow the steps below:
1- If the laser is not turned on, press the
2- Aim it at the place of measurement, holding it still, and press the
3- The result is shown on the display
button until selecting the desired reference.
FrontCenter
Picture 5 – Measurement Reference

Memory

button and hold it down for 2 seconds, the
button.

Unit of Measure (Metric, Feet and Inches)

button and hold it down for 2 seconds, for access, switch between units of
Metric
Feet Inches
system
0.000m 0.00ft 000.00in
m ft
m² ft²
m³ ft³
Table 3 - Units of measure

Simple Distance Measurement

button to turn it on;
Picture 6 - Simple distance measurement - indication on the display
Rear
symbol appears at the top of the display;
or buttons;
Inches
0'00" in
1/32
In 0'00"
1/32
ft² ft²
ft³ ft³
button again;
LMXP-100 ENG
Fractional inches
in in
1/32 1/16
In In
1/32 1/16
ft² ft²
ft³ ft³
in
1/8
In
1/8
ft²
ft³
6