Specifications - Dynex DX-E402 Manual De Instrucciones

Specifications

Note: After the above configuration takes effect, configure your router by typing
4 Log in to your router, click the Forwarding on the left of your browser, then click
Virtual Servers. The Virtual Servers page opens.
5 Click Add New. The Add or Modify a Virtual Server page opens.
6 Enter
example,
7 Select Enable for Status, then click Save.
Specifications
Standards
Protocols
Ports
Cabling Type
Power Supply
LEDs
Safety & Emissions
http://192.168.1.1:88 (your router's LAN IP address: Web Management Port) in
the address field of the Web browser.
into the Service Port field, and your IP address in the IP Address field (for
80
192.168.1.188
IEEE 802.3, 802.3u
TCP/IP, PPPoE, DHCP, ICMP, NAT, SNTP
One 10/100M Auto-Negotiation WAN RJ45 port. Four 10/100M
Auto-Negotiation LAN RJ45 ports supporting Auto MDI/MDIX
10BASE-T: UTP category 3, 4, 5 cable (maximum 100m)
EIA/TIA-568 100 ohm STP (maximum 100m)
100BASE-TX: UTP category 5, 5e cable (maximum 100m)
EIA/TIA-568 100 ohm STP (maximum 100m)
9V~ 0.8A
Power, System, Link/Act
FCC
Environmental and Physical
).
General
19