Tightening Torques; Troubleshooting - Chicago Pneumatic CP 1230 SPDR Instrucciones De Seguridad Y De Funcionamiento

CP 1230 SPDR, CP 1240 SPDR
4. Make sure that striking faces on the anvil block
are parallel and flat. If the block is cupped, grind
off high edges but do not touch the polished
face where the anvil strikes the steel shank.
Maximum allowed wear (A)
illustration shown below.
A
9800 0555 90a | Original instructions
1 ⁄ in. (1mm). See
32
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and operating instructions

Tightening torques

B
Torque: CP 1230 SPDR, 100-125 lbf.ft
A.
(135-170 Nm) and CP 1240 SPDR, 125-150
lbf.ft (170- 203Nm).
The cylinder seal must protrude approximately
B.
1 ⁄ in. (1.6 mm) before assembly of the back
16
head.
Torque: 125–150 lbf.ft (170-203Nm). Apply
C.
Loctite® 242™ (Loctite is a registered trademark
of Henkel Corporation. 242 is a trademark of
Henkel Corporation).
Torque, Muffler (not illustrated) 6–7lbf.ft
D.
(8–10 Nm).
E. Assembled length of spring or bushing.
Model
CP 1230 SPDR
CP 1240 SPDR

Troubleshooting

If the pneumatic machine does not start, has low
power or uneven performance, check the following
points.
A
C
E
Min-Max length
in. (mm)
2 1 ⁄ –2 3 ⁄ (54.0–55.6)
8 16
2 17 ⁄ –2 19 ⁄ (64.3–65.9)
32 32
15