Instruction To The Owner; Safety Instructions; Operation - Hyperion IRT-UVA 1 PrepCure 3 Digital Manual De Funcionamiento, Ensamble Y Piezas De Recambio

4.

Instruction to the owner

The owner of the mobile dryer must produce clear oper-
ating instructions, adapted to local site conditions, and
make these available to all users.
Mobile dryer users must adhere to these operating
instructions.
This appliance is not intended for use by persons (in-
cluding children) with reduced physical, sensory or men-
tal capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Dispose of spent items at the nearest environmental
protection facility for recycling.
The UV- radiation emission is:
according to EN12198 = Category 2
according to EN62471 = Risk group 3
Appropriate measures shall be taken.
5.

Safety instructions

Fire and explosion
Do not store, prepare or use solvent-containing mate-
rials within a 5 m/16 feet radius of the mobile dryer.
Flammable materials should not be placed close to a
drying device in use.
Never direct the cassette towards highly combustible
materials.
The dryer must not be exposed to paint fog, sanding
dust or solvents, due to fire and explosion risk. Further-
more, the lifetime of the dryer will otherwise be reduced.
Allow for sufficient cooling time of the dryer.
Electrical equipment
The mobile dryer is operated by highly dangerous electri-
cal voltage.
Accessing electrical equipment
Before accessing live parts, remove the main connector
from the wall socket. Only professional electricians may
have direct access into the electrical equipment.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Warning!
UV RADIATION CAN CAUSE PERSONAL INJURY
AND PROPERTY DAMAGE!
• To reduce risk of injury, or property damage
from UV radiation, read, understand, and follow the
following safety instructions. In addition, make
certain that anyone else that uses this heating
equipment follows these safety instructions as well.
4
• Hands, face and other parts of the body shall not
be exposed to heat and radiation.
Do not stay in front of the lamp cassettes during
curing without safety equipment.
• Always wear eye protection, gloves and protective
clothing. Failure to this may result in severe burns or
long-term injury to the eyes.
• If a person works around UV radiation while on
medications, the medication should be checked to
see if it would make the person more photosensitive.
• Do not look directly at the light source.
• Do not use if protective glass is broken or missing.
These glass filters the light from unwanted
radiation.
INDICATION DISPLAY OF ACTIVE
UV-LAMP AND REMAINING UV-
LAMP TIME SHOWN IN PERCENT
REMAINING UV-LAMP TIME BUTTON
DISPLAY FOR UV-LAMP SET/
PRE-SET RUN TIME. (DURING
CURING:
REMANING RUN TIME)
UV-LAMP TIME SETTINGS
START/STOP BUTTON
MAIN SWITCH
6.

Operation

Turn the main switch on.
Set the timer to the recommended time by pressing (+)
or (-) buttons. To start the unit, press the Start/Stop but-
ton. Also press Start/Stop button for an earlier termina-
tion of the curing.
To see the remaining life time of the UV-lamps select
one of the lamps according to above and then press the
button with the percent sign (%).
GB
IRT UVA 1 PrepCure 3 Digital
ACTIVE UV-LAMP
SELECTION
(NOT APPLICABLE)
714598 rev 4