Troubleshooting - Fagor IP-200X Manual De Instrucciones

9. TROUBLESHOOTING

Problem
The ON/OFF pilot light does not come on
when the appliance is plugged in.
The ON/OFF pilot light comes on but the
appliance does not heat up.
The appliance suddenly stops heating up
during functioning.
E3, E6
Fault code E7, E8
E1, E2, E4, E5, Eb, EC
10. INFORMATION FOR THE
CORRECT DISPOSAL OF ELECTRICAL
AND ELECTRONIC APPLIANCES
At the end of its working
life, the product must not be
disposed of as urban waste.
It must be taken to a special
local authority differentiated
waste collection centre or to
a dealer providing this service. Disposing
of a household appliance separately avoids
possible negative consequences for the
environment and health deriving from
inappropriate disposal and enables the
constituent materials to be recovered to
obtain significant savings in energy and
resources.
To remind you that you must collaborate
with a selective collection scheme, the
Possible cause
It is not properly plugged in.
The switch, fuse or cable are faulty.
An unsuitable pan is being used.
For other causes, consult the special
maintenance department.
The ambient temperature is too high.
The air vent or air inlet is blocked.
The timer setting has elapsed.
Check the protection system is working.
Carry out an activation test.
Wait for a moment and then press the
ON/OFF button. The hob should function
correctly when it has reached its normal
temperature again.
Press the ON/OFF button. The hob should
function correctly when it has reached its
normal temperature again.
Contact the authorised Technical
Assistance Service.
symbol shown appears on the product
warning you not to dispose of it in
traditional refuse containers.
For further information, contact your local
authority or the shop where you bought the
product.
12