Nice neomat Instrucciones Y Advertencias Para El Instalador página 4

4) Programming
Programming is divided into three stages:
1. Memorising the transmitters
2. Programming the "0" and "1" positions
3. Optional programming
!
WARNING: All the transmitter memorisation and para-
meter programming sequences are timed, i.e. they must
be carried out within set time limits.
4.1) Memorising the transmitters
Each radio control is recognised by the receiver incorporated in the NEOMAT control unit through an individual "code" that is unlike any other.
The control unit must therefore be programmed to recognise each separate radio control through a "memorisation" process.
When the memory does not contain any code, you can proceed to program the first radio control by operating as follows:
Table "A1" Memorising the first transmitter (fig 7)
1. When the control unit is switched on, you will hear two long beeps.
2. Within 5 seconds, press and hold down (for approx. 3 seconds) key
that must be memorised.
3. When you hear the first of the 3 beeps confirming the memorisation, release key
Note: If the control unit already contains codes, 2 short beeps will be heard when it is switched on. In this case you cannot proceed as
described above but must use the other memorisation method (Table "A2")
When one or more transmitters have already been memorised, additional ones can be enabled by proceeding as follows:
Table "A2" Memorising additional transmitters (fig 8)
1. Press and hold down (approx. 5 seconds) key
the beep.
2. Slowly press key
3. Press again key
4. Finally, 3 beeps will signal that the new transmitter has been correctly memorised.
Note: If the memory is already full (14 codes), 6 beeps will indicate that the transmitter cannot be memorised.
4.2) Programming the "0" and "1" positions
To program the positions you need to use a previously memorised remote control. Unless the "0" and "1" positions have been memorised in
the control unit, the movements require manual control. Initially the direction of the motor is not defined, but when step 1 in table "A3" has
been executed, the direction of the motor will be automatically assigned to the remote control keys.
To program positions 0 and 1 proceed as follows:
Table "A3" Programming the "0" and "1" positions (fig 9)
1. Press and hold down key
awning is complete and the motor has stopped automatically.
2. Press and hold down key
3. Release key
If necessary, adjust the position using keys
4. Press and hold down key
5. Release and then press again key
6. Press and hold down key
the position has been memorised.
4
on a previously enabled (old) transmitter 3 times.
on the new transmitter.
or on a memorised remote control until the closing of the
to lower the awning.
when the awning has reached the desired position ("1").
on the transmitter until you hear a beep (approx. 5 seconds).
for 5 more seconds until you hear 4 short beeps.
until 3 beeps and a brief up and down movement signal that
• For radio controls designed to handle multiple "units",
before proceeding with the memorisation you need to
select the unit to which the motor should be associated.
• All the motors within the range of the transmitter can be
programmed by radio; therefore, only the motor involved
in the operation should be kept switched on.
on the transmitter
on the new transmitter until you hear
and .
Example
3s
Example
5s
X3
Example
5s
5s