Installation; Location Requirements; Additional Requirements - Haier HWF5300AW Manual Del Usuario

INSTALLATION

Location Requirements

1. The proper location for your washer should have a flat and even floor. This will improve
performance, minimize noise and decrease washer movement.
2. The unit can be installed under a custom counter, in basement, laundry room, closet, or
other recessed area.

Additional Requirements

1. A grounded electrical outlet. Recommended less than 6 feet
from washer.
2. Hot and cold water faucets located less than 4 feet from
water fill valves with a water pressure of 4.4-145 psi.
3. It is not recommended to use washer on soft flooring such as
carpets or foam.
4. Do not operate washer if ambient room temperature is less
than freezing, may cause damage to unit.
Installation clearances
1. The optimal location for your
washer should be big enough to
open the washer door completely
for easy installation and servicing.
2. Allow some additional space
on the sides and rear for easy
installation, service and reduced
noise.
Water Connection
First, connect the elbow coupling end of the water inlet hose to the valve on the washer.
Then, connect the straight coupling end of the inlet hose to the water tap.
NOTE: 1. Do not crossthread when connecting inlet hose to the valve. Connect the cold
water tap to cold inlet on the washer and hot to hot.
2. Water supply pressure must be between 4.4 and 145 psi (30~1000kPa).
3. Over tightening may cause damage to the valve.
4. Check for leakage of washing machine connections by turning the tap completely
on.
6. Be sure that the two water inlet hoses are connected to the correct
water faucets.
before use.
27"
1"
(68.6 cm)
(2.5 cm)
1"
31 "
13/16
(2.5 cm)
(80.8 cm)
English
4"
(10.2 cm)
10