Preparing The Coffee - Brandt CTI-915 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

where the appliance is not to be used,
turn off the appliance and do not
attempt to repair. If a repair is required,
contact a Technical Assistance Service
authorised by the manufacturer and
request the use of original spare parts.
If the cable for this appliance is
damaged, contact an authorised
Technical Assistance Service for it to be
replaced.
Do not leave the appliance exposed to
the elements (rain, sun, ice, etc.).
Do not use or let any part of the
appliance come into contact or near
hot surfaces (kitchen gas or electric
hobs or ovens).
Do not use detergents or abrasive
sponges to clean the appliance.
Do not touch the hot surfaces. Use the
handles.
Do not let the cable come into contact
with the hot parts of the appliance.
Do not allow the liquid to evaporate. Do
not heat an empty jug.
Do not use a broken jug or one with a
loose or weakened handle. In the event
of any sign of deterioration, replace it.
Any crack or chip could break the jug
or contaminate the liquid contents with
glass shards.
Do not clean the jug with any type of
abrasive scourer or cleaning agent
which might scratch or weaken the
glass.
The jug is designed only for use with
this appliance. Do not place the jug on
or near hot surfaces (stoves, burners,
hotplates, hot ovens, microwave ovens,
etc.)
Do not place the hot jug on a damp or
cold surface.
Avoid brusque handling and knocks.
4. BEFORE USING THE APPLIANCE
FOR THE FIRST TIME
Before using your coffee maker for the
first time, familiarise yourself with all the
parts. Read all instructions carefully.
Open the container lid (2) upwards
(fig 2), take out the filter and the
filter holder (fig. 3) and clean them
together with the jug and the jug lid in
warm soapy water, rinse well, dry and
reassemble.
To clean the inside, operate the coffee
maker once or twice without putting
ground coffee in the filter. For this
process, follow the instructions under
the heading "Preparing the coffee".

5. PREPARING THE COFFEE

Place the coffee maker on a flat, stable
surface.
Open the container lid (2) upwards (fig 2)
and fill it with clean, cold water up to the
desired level. Do not exceed the container's
maximum level.
Fill the permanent filter (9) with the amount
of ground coffee you need and close the
lid. We suggest one level dessertspoonful
of ground coffee for each cup of coffee.
After using the coffee maker several times,
you may adjust the amount of coffee to
taste.
Place the jug onto the hotplate (5) with its
lid properly on. The jug will open the anti-
drip valve; if not, the filtered coffee will not
flow through to the jug and will overflow out
of the filter.
Take the cord out of the cord compartment
(11) and plug the appliance in at the mains.
Connect the coffee maker by pressing the
switch (8). The red pilot light will come on.
The switch light will indicate that the
appliance is in operation. The water will
start to filter through the coffee maker,
flowing into the jug.
When the coffee is ready, the Model CF-
1000 hotplate (5) will keep the coffee hot.
With model CTI-915, the thermal jug (12)
will keep the coffee hot even when you
switch off the coffee maker.
Disconnect the coffee maker by pressing
the on/off switch (8).
Unplug the appliance from the mains.
The coffee maker is provided with an anti-
drip system to prevent the coffee from
dripping onto the plate when the jug is not
correctly in place or when it is taken away
from the appliance.
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cf-1000

Tabla de contenido