Introduction; Insert The Batteries - Ebode TAKE 6 Guia Del Usuario

2) Program your 6 in 1 Universal Remote Control
1. Turn on the equipment that you wish to control ( TV, DVR, DVD, STB, AUX,
AUDIO).
2. The AUX key allows you to program and control any equipment such as TV,
DVR, DVD, CD, STB.
3. Take the code book supplied with the 6 in 1 Universal Remote Control and
find the brand of the equipment you wish to control. E.g. if you have a
Thomson TV look for Thomson under the TV section.
4. Press and hold on the key marked "S" (8) until the LED (2) stays permanently
on. This takes about 3 seconds. Release the "S key".
5. Press and release the TV, DVR, DVD, STB, AUX, AUDIO, mode key (4), in
accordance with the appliance you wish to control.
6. From the code book take the first number corresponding to your equipment
and enter the number by pressing the 0-9 key pad (14). Each time you press a
key the LED (2) will flash.
7. If the number is correctly entered the LED will turn off. If the number is
incorrect then the red LED will flash fast. If incorrect you will need to restart at
4.
Press the POWER key (1) . If your equipment switches off you have found the
right code. If it does not switch off, you will need to restart from 4.
Sometimes there are several codes that have similar features. If you find that
your 6 in 1 Universal Remote Control does not work for some functions, you
may need to try another code.

1. Introduction

The TAKE 6 is designed to control up to 6 devices:
TV, DVR, DVD, STB, AUDIO or any other device under AUX mode key. The TAKE
6 contains a library of codes that are preprogrammed into the remote control.
This library covers nearly all the audio video products on the market today. The
codes have to be programmed once before use. This can be done in different
ways:
a. Manual entry of one of the codes displayed under the related brand and
type of equipment in the attached code book (see 4.1)
b. Automatic code search for some well-known brands (4.2)
c. Automatic code search for all brands (4.3)
d. Manual search through all codes (4.4)
2. Insert the batteries (always use NEW CR2032 batteries)
1. Open the cover on the back of the TAKE 6 Remote.
2. Insert 2 CR2032 batteries, verify that they are placed correctly with the + on
the battery in the same position as marked inside the battery compartment.
3. Close the battery compartment carefully.
16-10-2009 4 033000=15299