Programming; Manual Code Entry - Ebode TAKE 6 Guia Del Usuario

IN TV mode: Coloured key (Blue), control of fasttext or special equipment
functions.
REC (record)
This key works the same way as the one on your original remote for your DVR.
In order to avoid a mistake you have to press this key twice to activate this
feature.
STOP
In DVR, DVD or CD mode: This button works the same way as in your original
remote.
IN TV mode: Coloured key (Green), control of fasttext or special equipment
functions.
PAUSE
In DVR, DVD or CD mode: This button works the same way as in your original
remote.
IN TV mode: Coloured key (Magenta), control of fasttext or special equipment
functions.
[16] AV
Selection of an external source (e.g. SCART input).
[17] INFO
Displays on screen information of the selected appliance (when available).
[18] Teletext
Teletext OFF: Stop Teletext / Fasttext.
[19] Teletext
Teletext Hold: Stop page change in Teletext / Fasttext mode.
[20] Teletext
Teletext Mix: Allows you to mix the Teletext / Fasttext and the picture of the
selected channel.
[21] Teletext
Teletext ON: Start/stop Teletext / Fasttext.

4. Programming

To make your remote suitable for your own equipment, you have to program it
once. You can do this by entering a code, related to the brand and type of
equipment you want to control. You can program any equipment under any
MODE key. For example, if you have three videorecorders, you can program
videorecorder 1 under DVR, videorecorder 2 under AUX and videorecorder 3
under AUDIO.

4.1. Manual code entry

Take your code book and search for the list matching the equipment you are
looking for, e.g. TV or DVR. Next, find the relevant brand (e.g. Sony). Now you
will find one or more 4-digit codes. If there is more than one code, it depends
on your equipment which code is correct. Generally, the codes are displayed
in order of age of the equipment. Older equipment first, younger equipment
at the end. Sometimes you will have to try several codes before you find the
right code for your equipment.
1. Make sure your equipment is switched on (for example TV).
2. Press and hold the S (8) key until the LED indicator lights continuously.
Release the S key.
3. Press and release the mode key (4) of the device you want to control (for
example TV).
4. Enter the 4-digit code from the Code Book by using the key pad (14). The
LED (2) turns off after the last digit is entered. If you entered a wrong code the
LED blinks for 3 seconds and then goes off. You have to repeat from step 2.
5. Point the remote in the direction of your TV and press the POWER button (1).
Your device should turn off. Check other functions (for example for a DVR FF or
REW, etc.). If certain functions are not responding, this indicates that the
entered code is not the correct one. In that case repeat the above
procedure with the next corresponding code of your brand.
16-10-2009 6 033000=15299