Onkyo LS5200 Manual De Instrucciones página 36

> Before Start > Part Names
0 Supported sampling rates for PCM signals (stereo, mono) from a digital input are 32kHz,
44.1kHz, 48kHz, 88.2kHz, 96kHz/16bit, 20bit, and 24bit.
■ 4. Analog Audio Input
You can change input assignment between the input selectors and AUDIO IN jacks. If you
do not assign a jack, select "-----".
BD/DVD "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
BD/DVD input selector. (Default Value is "AUDIO 1")
CBL/SAT "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
CBL/SAT input selector. (Default Value is "AUDIO 2")
GAME "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
GAME input selector. (Default Value is "-----")
STRM BOX "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
STRM BOX input selector. (Default Value is "-----")
CD "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
CD input selector. (Default Value is "-----")
TV "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
TV input selector. (Default Value is "-----")
PHONO (Default Value is "PHONO") The setting cannot be changed.
> Install > Initial Setup > Playback
2. Speaker
You can make changes to the connection environment of the speakers and change the
volume level. This setting cannot be selected if headphones are connected or audio is
output from the speakers of the TV because "5. Hardware" - "HDMI" - "Audio TV Out" is set
to "On".
■ 1. Configuration
Subwoofer Set whether a subwoofer is connected or not.
"Yes (Default Value)": When subwoofer is connected
"No": When subwoofer is not connected
0 Select "Yes" when using the included wireless subwoofer.
■ 2. Crossover
Front Select the crossover frequency from "40Hz" to "200Hz" to start
outputting frequencies for each channel. (Default Value is
"120Hz")
"Full Band": Full band will be output.
0 If "Configuration" - "Subwoofer" is set to "No", "Front" will be
fixed to "Full Band" and the low pitched range of the other
channels will be output from the front speakers. Refer to the
instruction manual of your speakers to make the setting.
LPF of LFE Set the low-pass filter for LFE (low-frequency effect) signals in
order to pass lower frequency signals than the set value and
thus cancel unwanted noises. The low-pass filter will be effective
only on sources with LFE channel.
The value from "80Hz" to "120Hz (Default Value)" can be set.
"Off": Do not use this function
Double Bass This can be selected only when "Configuration" - "Subwoofer" is
set to "Yes" and "Front" is set to "Full Band".
Boost bass output by feeding bass sounds from the front left and
right speakers to the subwoofer.
"On": Bass output will be boosted
"Off": Bass output will not be boosted
Advanced Setup | Firmware Update | Others
E
N
35