Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
HOW IT WORKS
The lock is composed of an external shell and a locking bracket. When the
key turns, it moves the locking lever into the bracket compartment allowing
the opening/closing of the device.
Opening:
When the key is inserted and turned clockwise, the lever is released from the
locking bracket.
Closing:
When the key is turned counterclockwise, the lever moves into the locking
bracket compartment closing the device; therefore, in order to lock the cargo
van it is sufficient to close the door.
Where you can install it:
The device can be installed both on the rear and on the side door of the van.
Caution: do not install the device on the forepart of the side door.
Before installing the device, check that the doors are perfectly aligned.
Prefer smooth surfaces to areas where the van body is irregular.
If necessary, use the plastic shims to level and/or align the surfaces
12
MOUNTING INSTRUCTIONS
Step 1
Use the adhesive drill template to mark the holes needed to install the device,
using the axes as a reference point.
• 3 holes ø5
A
for the locking bracket*;
• 3 holes ø5
D
+
F
F
or
D
fixing plate with fast-coupling system, according to your needs;
• 2 holes ø5
(recommended choice) or
B
B
shell to the van door;
• 1 hole ø4
for the emergency cable;
G
Fixing parts needed for the holes:
:long M5 hexagon head cap screw, fixed from the outside;
A
:short M5 hexagon head cap screw, fixed from the inside;
B
C
:long M5 countersunk screw, fixed from the outside;
D
E
F
F
E
D
G
F
E
Fig. 2: Drill template | NOT TO SCALE
*Place the adhesive drill template so that the shell is on the moving side of the doors
(shutter/sliding).
+
E
E
(recommended choice) for the
to fix the external
C
C
B
A
C
A
C
A
B
13
Publicidad
Tabla de contenido
