Quantum TURBO Compact Instrucciones De Operación página 4

When the charger is first connected the fuel gauge LED's turn on and off
during a brief self check. When the self-check finishes, charging begins
and the fuel gauge indicates charge progress.
The fuel gauge indicates charging progress as shown in the diagram.
25% charged 50% charged
= steady light
6. "CAMERA" AND "FLASH" OUTPUT INDICATORS
The indicators "Flash" [ ] and "Camera" [
sponding outputs.
A steady light means the output is supplying flash or camera
power.
A Blinking indicator shows when high voltage has shut down.
Off indicates no power for that output.
Typical examples are shown below:
CAMERA FLASH
Camera and Flash outputs supplying camera
and flash power.
C: Supplying camera power;
F: Not supplying power to flash.
C: Not supplying power to camera.
F: Supplying flash power.
C: Supplying camera power.
F: Blinking. Blinking will stop in 30 seconds.
An error condition has occurred and power to
flash has shut down.
75% charged 100% charged
= blinking = off
] show status of the corre-
4
7. ERROR CONDITIONS and TROUBLESHOOTING
Symptom
A flash or camera cable is
connected but the output
indicator is not lit.
"C" series Flash Cable is
connected to a flash and
the output light blinks for
30 seconds.
The fuel gauge's 25%
green light blinks for a few
minutes, and then all lights
go out and there is no power
to the equipment connected.
8. ACCESSORIES FOR TURBO C
Cables and accessories are updated continuously. Please consult
our website www.qtm.com, your dealer, or Quantum directly for the
latest availability.
"C" type Flash Cables for flash power - extend to 6' (2m):
All Flash Cables power flashes with Turbo, Turbo Z, Turbo 2x2 and
Turbo C.
CA Armatar*
CH Honeywell*
CK Nikon SB11, 24,
25, 26, 28-US
CKE Nikon*
CL3 Minolta 360PX
CL4 Minolta 4000AF
CL5 Minolta*
CM1 Metz 45CT-1, 5
CM4 Metz 45CL1,3,4,
45CT3,4;
Hasselblad 4504
QMC Multi Clip for attaching Turbo C to a belt.
Solution
The cable could be broken, shorted, or
it may be the wrong cable.
Turbo C has detected that no flash is
connected. This could be caused by
an intermittent or broken cable, or a
cable that is not fully engaged in the
socket.
This is the low battery indication.
Recharge. Check that the charger is
connected to a live mains outlet that
cannot be switched off.
CM5+ Metz*
CN3 Vivitar 3900
CO3 Olympus T32, T45
CS4 Sunpak*
CS5 Sunpak*
CS6 Sunpak 622
CV Vivitar*
CZ Canon*
5