Electrical Safety; Package Contents; Description (Fig. A) - DeWalt DW563 Manual De Instrucciones

E N G L I S H
18 Maintain tools with care
Keep the tools in good condition and clean for better
and safer performance. Follow the instructions for
maintenance and changing accessories. Inspect the
tool cords at regular intervals and, if damaged, have
them repaired by an authorized D
agent. Inspect the extension cords periodically and
replace them if damaged. Keep all controls dry,
clean and free from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for
damage to ensure that it will operate properly
and perform its intended function. Check for
misalignment and seizure of moving parts,
breakage of parts and any other conditions that
may affect its operation. Have damaged guards
or other defective parts repaired or replaced as
instructed. Do not use the tool if the switch is
defective. Have the switch replaced by an
authorized D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.

Package contents

The package contains:
1 Pistol Grip Heavy Duty Rotary Hammer Drill
1 Side handle
1 Depth adjustment rod
1 Kitbox (K-models only)
1 Keyed chuck + chuck adaptor
(DW563KC/DW566KC)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

Your D Walt Heavy Duty Rotary Hammer Drill
E
DW563(KC) has been designed for professional
drilling, hammer drilling and screwdriving
applications.
en - 3
Your D
DW566K(C) has been designed for professional
rotary and hammer drilling, screwdriving and light
chipping, chiselling, demolition applications and for
carbide tipped core drilling.
WALT repair
E
Torque limiting clutch
All Rotary Hammer Drills are equipped with a torque
limiting clutch that reduces the maximum torque
reaction transmitted to the operator in case of jamming
of a drill bit. This feature also prevents the gearing and
electric motor from stalling. The torque limiting clutch
has been factory-set and cannot be adjusted.

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Mains plug replacement
(U.K. & Ireland only)
Walt Heavy Duty Rotary Hammer Drill
E
1 Variable speed switch
2 Lock-on button
3 Forward/reverse lever
4 Mode selector
5 Side handle
6 Depth adjustment rod
7 Dust cover
8 Tool holder
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
16