DeWalt DW872 Manual De Instrucciones página 29

If adjustment is required, proceed as follows:
• Loosen the screws (38).
• Align the 0° marking on the scale (29) with the
edge of the slot (30).
• Retighten the screws (38).
Adjusting the spark deflector (fig. J)
• Loosen the screw (39).
• Set the spark deflector (40) as appropriate.
• Tighten the screw (39).
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Do not apply excessive pressure to the
tool.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Prior to operation:
• Install the appropriate cutting blade. Only use
sharp or correctly sharpened blades.
The maximum rotation speed of the tool must
not exceed that of the cutting blade.
• Make sure the blade rotates in the direction of
the arrows on the accessory and the tool.
• Secure the workpiece.
• Make sure all locking knobs and clamp handles
are tight.
• Always set the spark deflector correctly.
• Do not attempt to cut excessively small pieces.
Never perform cuts on small workpieces bundled
together.
Performing a cut (fig. A)
• Place the material to be cut against the fence (7)
and secure using the material clamp (6).
• Switch on the machine and pull down the control
handle (2) to cut the workpiece. Allow the motor
to reach full speed before cutting.
• Allow the blade to cut freely. Do not force.
• After completing the cut, switch off the machine
and return the arm to its upper rest position.
22
Switching on and off (fig. A)
The on/off-switch (1) of your chopsaw is mounted in
the control handle (2).
• To run the tool, press the on/off-switch (1).
• Keep the on/off-switch depressed while
performing the operation.
• To stop the tool, release the switch.
Do not switch the tool on or off when
under load.
Do not cut magnesium.
Consult your dealer for further information on the
appropriate accessories.
Transport (fig. L)
Your D WALT power tool is equipped with a lock-
E
down pin (36) which locks the tool in closed-down
position for carrying.
• Lower the guard (4) onto the cutting table (9)
and secure the power tool in this position by
pushing in the lock-down pin (36).
• Transport the power tool using the carrying
handle (3).
• To release the tool, pull out the lock-down pin (36).
Maintenance
Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
E N G L I S H
en - 7