Cleaning And Maintenance; Water Circuit - Master BCB 19 Manual De Instrucciones

en
►CLOCK: Is used to set the display clock.
►TIMING: Enables to activate or deacti-
vate the delayed switch-on or switch-off
mode.
-Delayed switch-on: With the cooler
switched on, press the "TIMING" button
to set the delayed start (act on the ▲ \
▼ buttons).
-Delayed switch-off: With the cooler
switched on, press the "TIMING" button
to set the delayed stop (act on the ▲ \
▼ buttons).
►SET: Sets some specific settings (press
the "SET" button several times and use
the ▲ \ ▼ buttons):
-P1: Mode not available.
-P2: Room temperature setting from
10°C to 40°C.
-P3: Mode not available.
-P4: Electric frequency setting from
40Hz to 60Hz.
-P5: Mode not available.
NOTE: When the display shows a red
LED and emits an acoustic beep, it
means that the tank is empty and must
be filled again ("COOL" function). To de-
activate the acoustic beep, deactivate
the "COOL" function.
During operation, a status LED lights up
on the display:
-GREEN LED (on): Cooler in operation.
-ORANGE LED (on): Cooler switching
on with low water level.
-GREEN LED (flashing): Communica-
tion problems between the display and
cooler.
-RED LED (on): Cooler switching off or
in stand-by with low water level.
►►4.3. SWITCH-OFF:
►4.3.1. Press ON/OFF / POWER to turn
off the cooler (Fig. 6).
►4.3.2. Drain the tank through the spe-
cific drain plug (Fig. 7).
►►5. CLEANING AND MAINTE-
NANCE
WARNING: BEFORE PERFORMING ANY
MAINTENANCE OR REPAIR, DISCON-
NECT THE POWER CABLE FROM THE
MAINS.
DEPENDING ON THE ENVIRONMENT
WHERE THE COOLER IS USED, DUST,
DIRT OR WATER QUALITY CAN AF-
FECT THE PERFORMANCE OF THE
UNIT. THEREFORE, CLEANING THE
FOLLOWING COMPONENTS MAY BE
REQUIRED:
►►5.1. TANK:
IT IS RECOMMENDED TO READ THE
SAFETY WARNINGS CAREFULLY AND
TO CHANGE THE WATER FREQUENT-
LY.
►5.1.1. Turn off the cooler and disconnect
the plug from the power mains.
►5.1.2. Drain the tank through the spe-
cific drain plug.
►►5.2. WATER CIRCUIT:
►5.2.1. To ensure proper operation of the
cooler, turn off the "COOL" mode a few
minutes before completely switching off
the cooler, in order to avoid stagnant
water.
►5.2.2. We recommend periodically per-
forming a complete cycle using clean
water and appropriate disinfection prod-
ucts, running the cooler outdoors.
IMPORTANT:
-The cooler tank must be emptied and
sanitised periodically depending on the
use.
-The cooling pad surfaces must be pe-
riodically inspected and sanitised de-
pending on the use.
-For sanitation operations, biocidal prod-
ucts that comply with European regula-
tion no. 582/2012 must be used.