Installation Instructions For Optional Black Glass Set; Installation Instructions Optional Lamels Set - Thermocet TRIMLINE Serie Instrucciones De Instalación

3. PLACING THE OPTIONAL BLACK GLASS, WALL OR LAMELS SET 73H DB (1133)
NOTICE
If you are selected a "Wall" or "Slats set" (optional to provide only for 73H DB 1133),
you must place it first before fitting the log and the Pebble set.
3.1 Installation instructions for optional Black glass set (see Appendix 9)
* Loosen the screws holding the bottom and top glass holders (2).
* Place the suction cup(s) in the middle of the glass-panel and remove the panel by GENTLY
moving this first upwards and then the lower edge of the glass-panel very carefully and slowly
pulling toward you. Then place in a safe place where the window can not be broken or damaged.
If the removed glass panel is damaged (scratched and / or damaged edges) then no longer use the
glass panel and contact your dealer.
* Place the Black glass set very carefully to avoid breakage or damage.
* Follow the instructions strictly as illustrated.
* Replace the decorative plate.
* After this, the Log or Pebble set can be placed.
3.2 Installation instructions for optional wall set (see Appendix 9)
* Place the wall set as indicated with regarding the walls which should be placed very carefully
to avoid breakage or other damage.
* Follow the instructions strictly as illustrated.
* Replace the Burner and decorative plate.
* After this, the Log or Pebble set can be placed.
3.3 Installation instructions Optional Lamels (see Appendix 9)
* Place the slats as shown with regarding the slats very carefully
should be placed in order to prevent damage to the lacquer.
* Now follow the instructions carefully as illustrated.
* Replace the Burner and decorative plate.
* After this, the Log or Pebble set can be placed.
Page.5