Flexinduction ® Cooking Zone - Bosch NITP668SUC Manual Del Usuario

Deep fat frying** (in 1-2 qt. oil)
deepfrozen foods, e.g. chicken nuggets (0.5 lb per serving)
other, e.g. doughnuts (0.5 lb per serving)
Keep warm
tomato sauce
* ongoing cooking without lid
** without lid
FlexInduction cooking zone
®
You can combine the elements into a large cooking zone
as needed or use two elements that are independent of
one another.
The FlexInduction cooking zone consists of 4 inductors,
®
which are controlled independently of one another. When
FlexInduction is in use, only the area is activated that is
®
covered by cookware.
Cookware use recommendations
Place the cookware in the middle. This guarantees
optimal pot detection and heat distribution.
Flexible cooking zone - as an individual element
Diameter of the cookware max. 5
(13 cm)
Place the cookware on one of the
4 positions visible in the figure.
Diameter larger than 5
Place the cookware on one of the
3 positions visible in the figure.
If the cookware takes up more than
one element, place it on the upper or
lower edge of the flexible cooking
zone.
Flexible cooking zone - two independent elements
The front and rear elements with two
inductors apiece can be used inde-
pendently. The heat setting is set indi-
vidually for each element. Use only
one piece of cookware on each ele-
ment.
As two independent elements
The flexible cooking zone is used like two independent
elements.
Turning on
See section on ~ "Setting the cooktop"
As a single element
Using the entire cooking zone by connecting both
elements.
Linking the two elements
The cooktop must be turned on.
1. Set down the cookware. Select one of the two
elements assigned to the flexible cooking zone and
set the power level.
Touch the Flex Join/Split key. The display lights up.
2.
The heat setting appears in the display for the lower
element.
The flexible cooking zone is activated.
Changing the power level
Select one of the element in the flexible cooking zone
and change the power level with the number keys.
Add another piece of cookware
X
"
Set the new item of cookware down on the cooktop,
select one of the two elements in the flexible cooking
zone and then touch the Flex Join/Split key twice. The
new item of cookware will be detected and the power
level that was previously selected will be retained.
X " (13 cm)
Note: If the cookware is moved to the element being
used or lifted up, the element begins an automaticsearch
and the heat setting selected previously isretained.
Separating the two elements
Select one of the two elements in the flexible cooking
zone and touch the Flex Join/Split key.
This deactivates the flexible cooking zone. The two
elements will now function independently.
Notes
If the element is switched off, and then switched back
▯
on again later, the flexible cooking zone is reset to
function as two independent elements.
To change the configuration settings for the flexible
▯
cooking zone, refer to the section on ~ "Basic
settings"
Power levels
8.0 - 9.0
4.5 - 5.5
1.5
13