Display Assembly Wall Mount Instructions; Required Parts - Health O Meter 498KL Instrucciones Para El Usuario

DISPLAY ASSEMBLY WALL MOUNT INSTRUCTIONS

Display Assembly Wall Mounting Instructions (Refer to Figure 4 on page 12)
Caution: When wall mounting the display assembly, ensure that the
mounting location is free of electrical lines, gas pipes, and other safety
hazards. Ensure that wall is of construction that can support the display
assembly.
Note:
Remote head can be mounted to a wall up to 6 feet (1.83 m) from the base or it can be
mounted on the display bracket (included) for placement on a table up to 6 feet (1.83 m) from
the base.
Note: For wall mounting, mount display assembly directly to the wall. Do not use display bracket
for wall mount. Display bracket is for surface use only.
1. Position the display assembly on the wall, and carefully trace around the
display outline.
2. Mark a level horizontal line, 2 ¾" (70 mm) below the top of the display outline.
3. Mark a vertical line 3.1" (80 mm) from each side of the display outline.
4. Use the appropriate plastic or metal anchors for the type of wall construction.
5. At the horizontal and vertical intersection, carefully drill the appropriate sized
holes.
6. Insert the anchors into the wall, and screw the two mounting screws into the
anchors. Adjust the screw head depth such that the screw heads protrude
1/8" (3.2 mm) from the wall.
Warning: Extending the screw heads beyond 1/8" (3.2 mm) can damage the
display assembly.
7. Position the display assembly mounting holes onto the mounting screws and
pull down on the display assembly to secure the bracket over the screws.

Required Parts

(1) Display assembly
(2) #8 Anchoring screws (4.2 mm nominal OD)
(2) Mounting anchors, compatible with wall construction
Note: Anchors and anchoring screws are not included with this scale.
11