Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.
TECHNICAL DATA HBS 300J
Voltage
Power
Idle run speed n
o
Blade length
Blade width
Blade speed
Cutting height 90°
Cutting height 45°
Table size
Tilting range
Max. workpiece size
weight
Nose emission values:
L
sound pressure level 92,7dB(A)
PA
L
sound power level
WA
6.
BEFORE
MACHINE
•
Make sure the machine stands securely,
i.e. bolt it to a workbench or solid base.
Fixing holes are provided in the base
plate for this purpose.
•
The
saw
table
assembled.
•
All covers and safety devices have to be
properly fitted before the machine is
switched on.
•
It must be possible for the blade to run
freely.
•
When working with wood that has been
processed before, watch out for foreign
bodies such as nails or screws etc,
•
Before you actuate the On/off switch,
make sure that the saw blade is
correctly fitted and that the machine`s
moving parts run smoothly.
•
Check that the voltage on the rating
plate is the same as your supply
voltage before you connect to the
power supply.
230V/400V ~ 50Hz
750W
-1
1400 min
2240mm
6-18mm
360/720 m/min
170mm
70mm
500 x 400mm
90° - 45°
600 x 600mm
83kg
102,3dB(A)
STARTING
THE
must
be
correctly
7.
ASSEMBLY
CAUTION! Pull out the power plug before
carrying out
any
resetting work on the machine!
7.1
Assembly of the sub-frame and
wheels (Fig. 3-5/27)
•
First attach the legs (21) loosely to the
base plate (5) of the machine using 2
screws for each leg. Use the round
head M8x12 screws to do so.
•
Screw the 2 long struts (41) and the 2
short struts (42) loosely to the legs
(21). The doubled-over part of the
struts must be at the top.
•
Attach the rubber feet to the legs (21).
•
Place the machine onto the legs
•
Align the entire base frame and tighten
all screws.
•
Fasten the holder (29) for the push
stock (28) as follows: Screw the lock
nut onto the bolt (29) and then screw
this into the housing until the push stick
(28) can be hung up.
7.2
Assembling the saw table (Figures
6-9)
•
Slacken the wing nuts (45) on the
underside of the saw table (15) and
remove the chain bar (2) from the saw
table.
•
Lead the blade through the slot (a) in
the
machine
machine table on the table guide so
that the clamping screw (47) fits
through the mounting (48).
•
Screw the saw table tight with the wing
nut (18).
•
Place the chain bar (2) onto the saw
table (15) so that the screw heads (50)
slide into the guide slots (51).
•
Check that the blade (25) runs freely
and does not touch the saw blade.
•
To
remove
proceed in reverse order.
ENGLISH
maintenance,
assembly,
table
and
place
the
saw
blade
guard,
the
Publicidad
Tabla de contenido
