Petsafe Staywell 900 Serie Manual De Instalación página 9

previous section) should you fit the collar key onto your cat's collar. When
fixing the collar to your cat, ensure that the collar key is positioned centrally
below your cat's chin. (Please note that the magnetic collar key is required
only to enter the cat flap).
Some cats can take time to get used to the operation of the magnetic cat
flap - some learning more quickly than others. The emphasis here is on
persistence; try using a favourite treat to not only coax your cat through the
cat flap, but to encourage the cat to move their head, and therefore their
collar key towards the base of the tunnel.
If your cat has only just become familiar with the using a cat flap, it may
take some patience to teach your cat how the magnetic function works.
When your cat makes progress, give them a lot of praise. Keep repeating
the exercise until your cat can come through the cat flap comfortably.
Replacement Flap Fitting
Instructions
1. From the inside of the house, ensure that the 4-Way Lock is in position 4
(In or Out).
2. If installed in a wall greater than 57mm thick, remove interior
frame cover from the interior frame by unsnapping the snaps, starting
with the snaps closest to the top on each side of the flap.
If installed in a door or wall less than 57mm thick, remove
the two blanking plugs (half-way down on either side of the exterior
frame) and then remove the screws. The cat flap will now come away
from the door. The part of the cat flap that is on the inside of the house
should be dismantled. To do this remove the screws from the back of the
interior frame. Remove interior frame cover from the interior frame by
unsnapping the snaps, starting with the snaps closest to the top on each
side of the flap.
3. Remove only the old flap and the flap magnet assembly, leaving the
jamb seal magnet and hinge springs in the frame.
4. Place the new flap into the frame ensuring that the flap seal magnet and
jamb seal magnet are attracting and not repelling. To ensure that this is
the case, on the flap, the word "PetSafe
5. If the flap was installed in a wall greater than 57mm thick,
place collar key on centre of tunnel. Reattach interior frame cover by
snapping it in place. Insert the bottom hooks of the frame cover first and
then rotate it into place. Reposition the 4-way lock to the desired setting.
If installed in a door or wall less than 57mm thick, reattach
interior frame cover by snapping it in place. Insert the bottom hooks of
the frame cover first and then rotate it into place. When the interior frame
and the interior frame cover edges are flush, turn the assembly over and
replace the screws. Replace the cat flap into the hole in your door/wall,
line up the outside frame and screw back into place. Re-cover the screw
holes with the blanking plugs and finally reposition the 4-Way Lock to the
desired setting.
Replacement flaps are available online at www.petsafe.net or by
contacting the Customer Care Centre. For a listing of Customer Care
Centre telephone numbers, visit our website at www.petsafe.net.
Replacement flaps available online
" should read from left to right.
®
9