Prepare The Receiver Collar - Petsafe Deluxe PCF-1000-20 Manual De Funcionamiento

Ground Wire
Proper grounding, although not necessary for the system to work, will help reduce the
chance of electrical surges causing damage to your Fence Transmitter and/or Power
Adapter. To ground your unit, you will need a solid (not stranded) Ground Wire (14 to
18 gauge insulated copper wire) and a ground rod with clamp, which may be obtained
at most electrical supply stores. Connect one end of the Ground Wire to the Ground
Terminal located on the Fence Transmitter and the other end of the Ground Wire to
the ground rod. The ground rod must be buried at least three feet into the ground and
located as close as possible to the Fence Transmitter.
Fuse Protection
The Fence Transmitter is also equipped with a 250 volt, ½ amp fuse to protect the unit's
electronic circuitry from electrical power surges. To locate the fuse, slide off the lid on
the back of the Fence Transmitter. A spare fuse is also provided.
Step

Prepare the Receiver Collar

5
To Insert and Remove the Battery
Note: Do not install the battery while the Receiver Collar is on your pet.
This Receiver Collar utilizes a replaceable PetSafe
(RFA-188). This unique battery is designed to make battery
replacement easier and increase water protection.
To activate the collar, insert the battery module (5A). Using the edge
of the Test Light Tool as shown, turn the battery clockwise until the
vertical line on the battery is pointed to the "ON" position (5B).
If the PetSafe
immediately, leave it in the "OFF" position.
To remove the battery, turn the battery counter-clockwise using
the edge of the Test Light Tool as shown (5C, 5D). DO NOT
attempt to cut into or pry open the battery. Be sure to discard the
used battery properly.
A replacement PetSafe
our website at www.petsafe.net for a listing of Customer Care Center
telephone numbers or for a listing of common retailers.
Two Colour LED
The two colour LED indicator shows good or low battery. Good battery equals 1 fl ash every 60 seconds with Green LED.
Low battery equals 3 fl ashes every 60 seconds with the Red LED. If there are no LED lights it is time to change the battery.
To Set the Static Correction Level
Read all steps before attempting to set the Static Correction Level.
1. With the battery installed, press the Correction Level Button and release when the
Receiver Indicator Light lights red (5E).
2. The Receiver Indicator Light will emit a number of red fl ashes representing the Static
Correction Level (5F).
3. Increase the Static Correction Level by pressing and releasing the Correction Level
Button within 5 seconds of the previous fl ashes.
The Static Correction Levels increase from 1 to 5. Pushing the Correction Level Button
while the Receiver Collar is on level 5 will cause the Receiver Collar to revert to level 1.
Refer to the Function and Response Table to choose the Static Correction level that best
fi ts your pet.
(4D)
(4E)
® Receiver Collar is not going to be used on the cat
®
battery can be found at many retailers. Visit
®
battery
www.petsafe.net
4D
4E
5A 5B
5D
5C
5E
5F
Ground
Wire
Spare Fuse Fuse
9