Safety Instructions For Planers; Original Accessories / Attachments; Preparing For Use; Switching On / Off - Parkside PEH 30 A1 Instrucciones De Utilización Y De Seguridad

General safety advice for electrical power tools / Preparing for use
If a dangerous situation arises, pull
the mains plug immediately out of the
mains socket.
When taking a break from your
work, before carrying out any tasks
on the device itself (e.g. changing the
plane blade) or when you are not us-
ing the device, always pull the mains
plug out of the mains socket.
Always work with the mains lead lead-
ing away from the rear of the device.
Use sharp planer blades only.
Do not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.
Avoid contact with rotating parts.
Never use the device for a purpose
for which it was not intended or with
non-original parts / accessories.
Hold the device securely when work-
ing. Ensure that you are standing in a stable,
well-balanced position.
Always keep the device clean, dry
and free from oil or grease.

Safety instructions for planers

Wait for the cutter spindle to stop completely
before setting down the power tool. An ex-
posed rotating cutter spindle can catch on the
surface, resulting in loss of control and serious
injuries.
Only hold the power tool by the insulated handle
areas as the cutter spindle may touch the tool's
mains cable. Contact with a live wire could
cause metal parts of the device to become live
and lead to electric shock.
Fix and secure the work piece to a stable sur-
face using clamps or other means. When only
securing the work piece by hand or against
your body it will remain unstable, which could
lead to loss of control.
40 GB/MT
©

Original accessories / attachments

Use only the accessories and attach-
ments detailed in the operating instruc-
tions. The use of attachments or accessories
other than those recommended here could lead
to you suffering an injury.
©

Preparing for use

©
Switching On / Off
Switching on:
First press the safety lock-out
Then press and keep pressed the ON / OFF
switch .
2
Switching off:
Release the ON / OFF switch
Note: For safety reasons the ON / OFF switch
cannot be locked in the ON position.
©

Setting the cutting depth

The rotary control can be used to set the cutting
13
depth in steps from 0–3.0 mm according to the cut-
ting depth scale .
14
© Vacuum extraction of dust /
debris (see Fig. A)
DANGER OF INJURY!
Before you carry out any work on the device always
pull the mains plug out of the mains socket.
Planing debris removal port (right / left
selectable):
Release the planing debris removal port
turning it against the direction of the arrow (out
of the "Lock" position).
Pull the planing debris removal port
the device.
The planing debris removal port
to face left or right in the planer.
1 .
.
2
2
by
3
out of
3
3 can be set