Parking Shoe; The Planing Process; Chamfering Edges; Using The Guide Fence - Parkside PEH 30 A1 Instrucciones De Utilización Y De Seguridad

Push the planing debris removal port
the device.
Lock the planing debris removal port
turning it into the "Lock" position.
External vacuum extraction:
If necessary fit the reducer piece
a dust extraction system, e.g. a workshop dust
extraction system.
The vacuum cleaner / dust extraction device used
must be suitable for the material being planed.
Connection:
Place the reducer piece
planing debris removal port
Push the hose of a suitable dust extraction device
approved for that purpose (e.g. a workshop
vacuum cleaner) on to the planing debris remov-
al port or the reducer piece
3
Removal:
Pull the hose of the dust extraction device off
the planing debris removal port
reducer piece 15 .
Pull off the reducer piece
© Parking shoe (see Figs. B / C)
The parking shoe allows you to lay the device
16
down without the risk of damaging the workpiece.
When planing, the parking shoe
exposes the rear part of the sole
©

The planing process

CAUTION! DANGER OF KICKBACK!
Always switch on the device before placing it
against the workpiece.
Set the required cutting depth.
Switch on the device.
Always place the front part of the sole
first on to the workpiece.
Guide the device with even forward movement
over the surface being planed.
Move the device forward at a slow rate and
ensure that the contact pressure acts evenly on
into
3
3 by
when using
15
15 firmly on to the
3 .
.
15
or off the
3
15 , if fitted.
swings up and
16
.
9
down
9
the sole . Moving forward at too great a rate
9
results in a poorer surface quality and can lead
to blocking of the planing debris removal port.
© Chamfering edges (see Fig. H)
The V-grooves in the front sole
10
to be used for simple chamfering of workpiece edges.
Use the V-groove most appropriate to your
desired chamfer width.
Place the planer with the V-groove
piece edge and guide the planer along the edge.
© Using the guide fence (see Fig. I)
Attach the guide fence
the fixing screw
7
Release the fixing nut
the desired distance.
Retighten the fixing nut
Exert some slight sideways pressure when guid-
ing the planer with the guide fence.
©

Using the rebate depth stop

(see Fig. J)
Attach the rebate depth stop
with the fixing screw
Set the desired rebate depth with the rebate
depth stop .
12
Make the required number of passes with the
planer until desired rebate depth is achieved.
© Removing and installing a
planer blade
DANGER OF INJURY!
Before you carry out any work on the device always
pull the mains plug out of the mains socket.
CAUTION! The sharp cutting edges of the plan-
er blade present an injury hazard! Never
20
touch the cutting edges of the planer blade
Preparing for use
allow the device
9
on the work-
10
to the device with
6
.
and set the guide at
8
.
8
to the device
12
.
11
(see Fig. D)
20
GB/MT
20 .
41