Safety Regulations; Technical Data - EINHELL DS 5 Manual De Instrucciones

GB

Safety regulations:

The pressure sprayer is designed for spraying
common home and garden solutions. This is pri-
marily meant to include pesticides, weed killers
and liquid fertilizers.
The pressure sprayer is not designed to spray
acidic and caustic liquids. Nor should it be used
to spray impregnating agents.
Only use a suitable nozzle wire or cleaning agent
to clean clogged nozzles.
Do not spray contents of sprayer on persons or
animals.
Always wear protective clothing when spraying
pesticides and insecticides.
Ensure that liquid sprays are not heated beyond
the permitted operating temperature of 40 °C.
When mixing and working with spray solutions,
always follow the manufacturer's instructions.
Each time the spraying unit has not been used
for an extended period of time it should be
checked for possible damage prior to reusing it.
Immediately replace defective parts.
Use only original replacement parts.
Do not leave the unit (filled or empty) in direct
sunlight.
Before placing the unit in winter storage,
thoroughly clean and dry it out so that it is not
damaged by freezing temperatures.
We will not be liable for any damage that results
from improper repairs and/or improper handling
of the unit (e.g. using the unit in ways for which it
was not intended).
Opening the unit or performing maintenance
work on it is only permitted when the tank is
depressurized.
To relieve the pressure, pull up the funnel-sha-
ped knob connected to the safety valve.
Only spray pesticides that have been approved
by the German Biological Research Center for
Agriculture and Forestry (BBA) or equivalent.
Please observe the safety data sheets for chemi-
cal materials and preparations compliant with
DIN 52 900, „DIN Safety Data Sheet for
Chemical Materials and Preparations".
Pesticides include - but are not limited to - herbi-
cides, insecticides, fungicides and growth regula-
tors as well as materials that are intended to be
used in conjunction with these agents in order to
modify their properties or effects.
4
Maintenance
To change the pump membrane, pull up the
pump lever as far as it will go, turn it counter-
clockwise until you come against notable resi-
stance, and then turn it a little further counter-
clockwise until the cover plate and the bayonet
separate.
Press the membrane plate out of its holder, ins-
ert a new membrane and lubricate it with acid-
free grease.
After using the unit and prior to performing any
maintenance work, always relieve the pressure
by simply pulling up on the funnel-shaped knob
connected to the safety/overpressure valve (let-
ter A, Fig. 2).

Technical data

Pressure sprayer
Max. filling capacity
Total filling capacity
Volumetric flow rate, Vmax =
Permissible operating pressure
Permissible operating temperature
Safety valve / vent valve
Nozzle
Nozzle spraying angle
Repulsion angle at the nozzle
DS 5
5 l
8 l
1.07 liters/min.
3 bar
+ 40°C
1
hollow cone 1 mm
max. 60°
less than 5N