Eu Declaration Of Conformity - i.safe MOBILE IS725.2 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 24
ENGLISH
INTRODUCTION
This document contains information and safety regulations which are to be observed without
fail for safe operation of the device IS725.2 under the described conditions . Non-observance
of this information and instructions can have serious consequences and / or may violate
regulations .
Please read the manual and these safety instructions before using the device . In case of any
doubt, the German version shall apply .
The current EU-declaration of conformity, certificates, safety instructions and manuals can be
found at www.isafe-mobile.com or requested from i.safe MOBILE GmbH .
RESERVATION
The content of this document is presented as it currently exists . i.safe MOBILE GmbH does
not provide any explicit or tacit guarantee for the accuracy or completeness of the content of
this document, including, but not restricted to, the tacit guarantee of market suitability or fit-
ness for a specific purpose unless applicable laws or court decisions make liability mandatory .
i.safe MOBILE GmbH reserves the right to make changes to this document or to withdraw
it any time without prior notice . Changes, errors and misprints may not be used as a basis for
any claim for damages . All rights reserved .
i.safe MOBILE GmbH cannot be held responsible for any data or other loss and direct or
indirect damages caused by any improper use of this device .
EX-SPECIFICATIONS
The device IS725.2 is suitable for use in potentially explosive atmospheres classified as zone
2/22 in accordance with directive 2014/34/EU, as well as the IECEx scheme .
EX-MARKINGS
ATEX:
II 3G Ex ic IIC T4 Gc IP54
II 3D Ex ic IIIB T150°C Dc IP54
EU Type Examination Certificate:
EPS 19 ATEX 1 130 X
CE-designation:
IECEx:
Ex ic IIC T4 Gc IP54
Ex ic IIIB T150°C Dc IP54
IECEx Certificate: IECEx EPS 19 .0065X
EU-DECLARATION OF CONFORMITY
The EU-declaration of conformity can be found at the end of this manual .
FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it must
be withdrawn from use and removed from any ex-hazardous areas immediately . Measures
must be taken to prevent any accidental restarting of the device . The safety of the device may
be compromised, if, for example:
4
Temperature range:
-20°C ... +60°C
Manufactured by:
i.safe MOBILE GmbH
i_Park Tauberfranken 10
97922 Lauda-Koenigshofen
Germany

Publicidad

Tabla de contenido
loading

Tabla de contenido