Panels Mounting; Decorative Door And Bottom-Drawer Panels Layout - Fulgor Milano Professional 36 Built-In Serie Guia De Instalacion

5. Panels Mounting

EN
Professional Built-In SERIES
5.1 Decorative door and Bottom-Drawer panels
layout
The dimensions of the panels are indicated in the table and
drawings on subsequent pages.
Nevertheless, according to the requirements for aligning
with other kitchen structures, the door panel can be higher
than the upper edge of the refrigerator door, and the drawer
panel can be lower than the edge of the drawer.
The panels must be mounted using special brackets which
attach to adjustable devices provided on the door and
drawer and with brackets that anchor and adjust the panel's
vertical direction.
Brackets and fixing screws are provided with the appliance
and must be applied to the panel as indicated.
Operate as follows:
To prepare the panels to be mounted on the appliance,
follow these steps, working on the back of the panel.
Door Panel
• Draw a vertical center line on the panel from top to
bottom [ 1 ].
• Starting from the bottom edge of the panel, mark the
positioning of the brackets [ 2 ].
2
10
• Following the corresponding table, mark the external and
then the internal hole [ 3 ].
3
• Position the brackets on each set of marks to make sure
they are aligned [ 4 ], if you choose to drill small pilot
holes for the screws pay special attention to not pass
through the panel entirely. [ 5 ].
4
1
• Screw the brackets in place [ 6 ].
5 6