Input Mode - D.A.S. DSP-26 Manual De Usuario

The sending unit should now display the following screen.
If communication is successful then a progress percentage will be shown on the sending unit. When
this reaches 100% the sending unit will return to the MIDI dump default screen and the MIDI dump
is complete.
NOTE: A system dump received by a different model can wipe all the memory information from that
unit. If you have several different models linked together and you wish to perform sysex dumps
between them make sure that all that should not receive the dump information are either switched off
or set to another MIDI channel.
10. Input

10.1 Input Mode

There are three input sections: Input A, Input B and Input Sum(A+B). Delay and EQ can be added to
Inputs A, B and stereo linked A&B but only delay is available directly to the Sum A+B.
10.2 Input Delay
Delay is available from 0-635ms in 21 us increments for Input A, Input B and Input A+B. There
cannot be more than 635.417 ms of delay on any input to output path.
Delay units to represent this value, as either milliseconds, feet or frames per second are set in the
utilities section.
10.3 Input EQ
Inputs A, B (and A& B)can have EQ assigned to then. High and low shelving with 12dB or 6dB/Octave
slopes as well as full parametric bell curves are available. To add EQ to Input Sum A+B, adjust EQ
parameters on the individual unmixed inputs(A,B)which are then summed into Input A+B.
11. Outputs
There are six output sections: output1~output6
The Output parameter screens are accessed by pushing the knob.
11.1 Stereo Linked Outputs
When the unit is Stereo Linked, combinations of Outputs are linked so that when changing parameters
such as EQ or Crossover settings, both channels change together.
In 2 channel 3 way configuration, Output 1 and 2 parameters, Output 3 and 4 parameters and Output
5 and 6 parameters are ganged in pairs.
DSP-26
MIDI DUMP
PREPARING...
IN B
DELAY 0.007M
IN A & IN B
Eq1 BE11
Manual del usuario/ User´s manual
OPERATION
*
*
Sp12
35