D.A.S. DSP-26 Manual De Usuario página 40

OPERATION
In LCD 2 way configuration Outputs 1,3 and 5 are linked as are 2, 4 and 6.
When Outputs are linked, the band name is derived from the channel assigned to the lower numbered
Output. Similarly, if the linked Outputs are offset, the parameter value for the lower numbered Output
is displayed. To see the values set for the higher numbered Output turn Stereo Link off.
11.2 Output Name
The Output band name is selectable from a pre-programmed list. Use the and button or encoder to
scroll through the list. Choose a name that most appropriately describes the usage for each channel.
Available names:
L Low, L Mid, L High
R Low, R Mid, R High
C Low, C Mid, C High
Subs, Low, Low Mid, Mid, Hi Mid, High
Mid+High
1"Horn,1.5"Horn,2"Horn
Bullet
Flat
Unused
Bar, Bstage
Delay
Center
Mono
Aux
Delay 1-6
10", 12", 15", 18", 21", 24"
L Subs, C Subs, R Subs
Source
Choose which Input or combination of Inputs supplies the Output channel.
The options are: Input A, Input B or the sum of Inputs A and B-denoted as Input A+B. When Stereo
Linked in 2 channel 3 way mode, the selection is normally Inputs A&B.
11.3 Gain
Output channel gain is adjustable from -15dB to +15dB in 0.2dB steps. The nominal setting for
Outputs is 0dB.
36
OUT 1 & 2 Band1
NAME
OUT 1&2 Band1 *
SRCE IN A&B
OUT 1&2 BULLET
GAIN -13.4DB
Manual del usuario/ User´s manual
Band1
DSP-26