Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
in these steps needing to be
followed again.
Battery Replacement
To replace the battery:
1. Slide battery cover open on
the hand held transmitter
2. Correctly install one 12 Volt
(A23) battery in the battery

Maintenance

  WARNING: Disconnect power
before attempting any main-
tenance or cleaning to reduce
the risk of fire, electric shock or
damage to persons.
!
NOTE: The fireplace should
not be operated with an accumu-
lation of dust or dirt on or in the
unit, as this can cause a build up
of heat and eventual damage. For
this reason the heater must be
inspected regularly, depending
upon conditions and at least at
yearly intervals.
Light Bulb Replacement
Light bulbs need to be replaced
when you notice a dark section
of the flame. There are two bulbs
under the log set which generate
the flames and embers.
holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
Light Bulb Requirements
Quantity 2 clear chandelier or
candelabra bulbs with an E-12
(small) socket base, 60 Watt rat-
ing. Example: GE 60BC or Philips
60CTC.Do not exceed 60 Watts
per bulb.
Replacement:
CAUTION: Allow at least 10
minutes for the light bulbs and
heater to cool before attempt-
ing any maintenance or clean-
ing.
1. With a Phillips screwdriver
remove the screws from the
Log Grate (Figure 3).
2. Remove the Log Set by lifting
straight up.
!
NOTE: Log Set fits tightly
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dfi2310

Tabla de contenido