Operation
Figure 1
WARNING: This electric
firebox must be properly installed
before it is used.
Manual Controls
A - 3-Position Switch
The switch has two On positions
marked with " I " and " II ". The " I
" position is for manual operation.
In this position the built-in remote
control is bypassed.
The " II " position is for operating
the unit with the provided remote
control. When in " II " position the
unit is operated with the ON and
OFF buttons of the remote con-
trol.
When the switch is in the center
("O") position the unit is off.
B - Low Heat On/Off Switch
The Low Heat On/Off Switch
supplies power to the heater fan
C
and the heater element. When the
switch is in the ON position the
heater operates on LOW.
C - High Heat Switch
The High Heat On/Off Switch
supplies power to the heater fan
and the heater element, when the
switch is in the ON position the
heater operates on HIGH. The
Low Heat Switch must also be in
the ON position for the high heat
setting to operate.
!
NOTE: The heater on your
fireplace may emit a slight,
harmless odor when first used.
This odor is a normal condition
caused by the initial heating of
internal heater parts and will
not occur again.
Resetting the Temperature Cut-
off Switch
The heater is protected with a
B
A
9