Disposal Of Packaging Materials; Connection - Clatronic AR 815 USB/CR Manual De Instrucciones

Disposal of Packaging Materials

The packaging protects the device from transport damage. The
packaging materials are selected in environmentally friendly and
disposal aspects and are recyclable.
Recycling of packaging materials saves raw materials
and reduces the waste. Dispose of unwanted packag-
ing in accordance with local regulations.
NOTE
►
If possible, keep the original packaging for the duration of the
warranty period, in order to be able to properly package the
device in the event of warranty claims.

Connection

WARNING
During installation damages may occur!
►
Have the unit installed by a specialized workshop, if possible.
►
Please observe all installation and connecting instructions for
safe and trouble-free operation if installing the unit yourself.
CAUTION
Wrong connections may damage the unit .
►
Use the ISO connectors when installing the unit. Vehicle-
specific ISO adapters are available at the specialized car
accessories trade, if necessary.
Rear Panel Connections
E
A ISO connector B (speakers)
B Vehicle flat fuse (5 A)
C ISO connector A (power supply)
D LINE OUT:
RCA audio output L/R for amplifier
E Antenna connector
68
All manuals and user guides at all-guides.com
Configuration ISO Connectors
ISO connector A
ISO connector B
CAUTION
►
►
►
►
►
A
Auto Antenna Power Supply A5 (ISO A)
D C B
CAUTION
Damage to the unit is possible!
►
►
The terminal for antenna power is provided for a relay-controlled
antenna. The relay automatically extends the antenna when the radio
is turned on. The antenna retracts again when the radio is turned off.
This terminal can also be used for an external amplifier. Please find
details in the amplifier's manual.
Connect External Amplifier
Connect an external amplifier via LINE OUT. Please find details in the
amplifier's manual.
1 Not connected
2 Not connected
3 Not connected
4 Continuous plus (memory)
5 Control voltage for electronic/
motor antenna or power ampli-
fier
6 Not connected
7 12 V (ACC)
8 GND
1 Speaker rear right +
2 Speaker rear right -
3 Speaker front right +
4 Speaker front right -
5 Speaker front left +
6 Speaker front left -
7 Speaker rear left +
8 Speaker rear left -
Use speakers with an impedance of at least 4 Ohm.
The speaker cabling must be floating ground.
NOTE
For connecting the unit to two speakers only use only front
speaker cables.
Please observe that for the station memory connector 4 must
be connected to continuous positive.
In some vehicle models the standard configuration for con-
nectors [4] and [7] (ISO A) is inverted. In this case the station
preset can get lost. To remedy invert these connections 7
(ACC) and 4 (continuous positive).
Do not connect the terminal for antenna power to the power
supply of the antenna.
Max. load: 100 mA.