Installation And Removal; Mounting Instruction - Clatronic AR 815 USB/CR Manual De Instrucciones

Installation and Removal

The unit can be installed in any ISO installation slot. Please contact
the car manufacturer or the local dealer if your vehicle does not
come with an ISO slot.
NOTE
►
Before installation remove the two transport securing screws.
►
Connect all cables before mounting the unit. Ensure all con-
nections are correct and the system works properly.
Important additional information for installation of your car
radio!
1. The set is designed for an installation where the negative pole
of the battery must be connected to the vehicle chassis. Please
check this before installation.
2. Please note for installation/connection of your set that not every
vehicle is equipped with an "ISO connection". In this case we
recommend the use of a vehicle-specific ISO adapter.
Adapters are available from car accessory sellers and/or your
car workshop.
3. The connection of "Continuous +" (continuous current connec-
tion) may differ depending on the vehicle type. (However, this is
required for storing of the radio stations.)
In order to assure all functions, installation according to these
instructions is necessary. In case of doubt, please contact an
authorized car workshop.
Because of the different vehicle types and vehicle manufac-
turers, correct wiring of the ISO connector is no assured even
when the ISO plug connectors fit mechanically. Thus it may be
necessary to change the electric connection or to use a vehicle-
specific adaptor.
NOTE
►
In case of correct connection, the radio can be switched on
and off with the ignition. In case of possible loss of stored
radio stations, the radio is not provided with the "Continuous
+" required for station storage.
CAUTION
►
In case of connection to "Continuous +" without ignition, an
unnecessary load may be caused for the car battery even
when the radio is switched off. In the worst case, this may
lead to discharge of the car battery.
All manuals and user guides at all-guides.com
4.
5.
6.

Mounting Instruction

‹
‹
‹
‹
‹
‹
‹
‹
Depending on the vehicle type, interferences may occur
during operation of the radio. These can be eliminated with an
additional noise filter. Your set is already equipped with a noise
filter as standard. In spite of this, interferences may be caused
depending on the vehicle.
Noise filters are available from car accessory sellers and/or
your car workshop.
When installing your radio, take care that there is sufficient free
space at the rear of the radio to assure sufficient cooling.
There are two different standards for the antenna connection.
The first one is the old one (50 Ohm) with a long projecting
round contact on the vehicle side and a round socket on the
radio side. The second one is the ISO standard antenna plug
(150 Ohm). Adapters for both formats are offered by car acces-
sory sellers and/or your car workshop.
NOTE
►
To be strictly observed for VW/Audi: The antenna of
your vehicle may be an active antenna. This requires a
voltage supply only provided by the original car radios. If
this should be the case, please use an antenna adapter
for phantom feed.
Antenna adapters are available from car accessory sell-
ers and/or your car workshop.
The correct tools are self-explanatory for a car hifi installation.
Insert the unit into the ISO slot or select a location where you
can reach all controls and the unit is not in the diver's way.
Connect only to a properly installed 12V battery.
Connect only via the ISO connectors.
Install the unit in such way that no overheating is possible and
the unit is well ventilated.
º the unit might not perform
If the installation angle exceeds 30
well.
Avoid installing the unit where it is subjected to high tempera-
ture, such as from direct sunlight, hot air from the heating
ducts, or where subjected to dust, dirt or excessive vibration.
Contact your car manufacturer or the local dealer if vehicle
modifications are necessary.
69