Sony XAV-AX5000Q2 Manual De Instrucciones página 18

Notes on LCD panel
• Do not get the LCD panel wet or expose it to
liquids. This may cause a malfunction.
• Do not press down hard on the LCD panel as doing
so can distort the picture or cause a malfunction
(i.e., the picture may become unclear or the LCD
panel may be damaged).
• Do not touch the panel with objects other than
with your finger as it may damage or break the
LCD panel.
• Clean the LCD panel with a dry soft cloth. Do not
use solvents such as benzine, thinner,
commercially available cleaners, or antistatic spray.
• Do not use the unit outside the temperature range
0 ºC – 40 ºC (32 ºF – 104 ºF).
• If your car was parked in a cold or hot place, the
picture may not be clear. However, the monitor is
not damaged and the picture will become clear
after the temperature in your car becomes normal.
• Some stationary blue, red, or green dots may
appear on the monitor. These are called "bright
spots" and can happen with any LCD. The LCD
panel is precision-manufactured with more than
99.99% of its segments functional. However, it is
possible that a small percentage (typically 0.01%)
of the segments may not light up properly. This
will not, however, interfere with your viewing.
Notes on the touch panel
• This unit uses a capacitive touch panel. Touch the
panel directly with your fingertip.
• Multi-touch operation is not supported on this
unit.
• Do not touch the panel with sharp objects such as
a needle, pen, or fingernail. Operation with a
stylus is not supported on this unit.
• Touching the panel with a gloved finger may cause
the unit to operate incorrectly or not respond.
• Do not let any objects contact the touch panel. If
the panel is touched by an object other than your
fingertip, the unit may not respond correctly.
• Since glass material is used for the panel, do not
subject the unit to strong shock. If cracking or
chipping occurs on the panel, do not touch the
damaged part as it may cause injury.
• Keep other electrical devices away from the touch
panel. They may cause the touch panel to
malfunction.
• If there are water droplets on the touch panel, or if
you touch the panel with wet fingertips, the touch
panel may not react correctly.
18
GB
Supported formats for USB playback
USB1 port:
 WMA (.wma)*
1 * 2
Bit rate: 48 kbps – 192 kbps (Supports variable bit
rate (VBR))* 3
Sampling frequency*
 MP3 (.mp3)*
1 * 2
Bit rate: 48 kbps – 320 kbps (Supports variable
bit rate (VBR))* 3
Sampling frequency*
 AAC (.m4a)*
1 * 2
Bit rate: 40 kbps – 320 kbps (Supports variable
bit rate (VBR))* 3
Sampling frequency*
Bit per sample (Quantization bit): 16 bits
 FLAC (.flac)*
1 * 6
Sampling frequency*
Bit per sample (Quantization bit): 16 bits
 WAV (.wav)*
1
Sampling frequency*
Bit per sample (Quantization bit): 16 bits, 24 bits
 Xvid (.avi)
Video codec: MPEG-4 Advanced Simple Profile
Audio codec: MP3 (MPEG-1 Layer3)
Bit rate: Max. 4 Mbps
Frame rate: Max. 30 fps (30p/60i)
Resolution: Max. 1280 × 720*
 MPEG-4 (.mp4)
Video codec: MPEG-4 Advanced Simple Profile,
AVC Baseline Profile
Audio codec: AAC
Bit rate: Max. 4 Mbps
Frame rate: Max. 30 fps (30p/60i)
Resolution: Max. 1280 × 720*
 WMV (.wmv, .avi)*
1
Video codec: WMV3, WVC1
Audio codec: MP3, WMA
Bit rate: Max. 6 Mbps
Frame rate: Max. 30 fps
Resolution: Max. 720 × 480*
 MKV (.mkv)
Video codec: MPEG-4 Advanced Simple Profile,
AVC Baseline Profile
Audio codec: MP3, AAC
Bit rate: Max. 5 Mbps
Frame rate: Max. 30 fps
Resolution: Max. 1280 × 720*
USB2 port:
 WMA (.wma)*
*
1 2
Bit rate: 48 kbps – 192 kbps (Supports variable bit
rate (VBR))* 3
Sampling frequency*
 MP3 (.mp3)*
1 * 2
Bit rate: 48 kbps – 320 kbps (Supports variable
bit rate (VBR))* 3
Sampling frequency*
 FLAC (.flac)*
1
Sampling frequency*
Bit per sample (Quantization bit): 8 bits, 16 bits,
24 bits
4 : 44.1 kHz
4 : 32 kHz, 44.1 kHz, 48 kHz
4 : 8 kHz – 48 kHz
4 : 8 kHz – 48 kHz
: 8 kHz – 48 kHz
4
5
5
5
5
4 : 44.1 kHz
4 : 32 kHz, 44.1 kHz, 48 kHz
4 : 8 kHz – 48 kHz