Installation Of Remote Controller - LG LK-0580CC Instrucciones De Instalación Y Mantenimiento

7. Installation of remote controller

• Install the remote control box and cord correctly.
POINT OF REMOTE CONTROLLER INSTALLATION
• As the room temperature sensor is in the remote controller, the remote control box should be
installed in such places away from direct sunlight and high humidity and direct supply cold air.
INSTALLATION OF THE REMOTE CONTROL BOX
• Select places that is not splashed by water.
• Select control position after receiving customer
approval.
• The room temperature sensor of the thermostat for
temperature control is built in remote controller.
• This remote controller equipped with liquid
crystal display. If this position is higher or lower,
display is difficult to see.
(The standard height is 1.2~1.5m high)
ELECTRICAL WIRING TO THE INDOOR UNIT
Remote controller
Yellow, Red, Brown
If the length of the cord exceeds 50m, use a wire size greater than 0.5mm
DISASSEMBLING OF THE REMOTE CONTROLLER
Lever carefully
under plate and open
using a screw
driver, etc.
WHEN THE REMOTE CONTROLLER IS
INSTALLED WITH THE CORD BURIED.
PROCEDURE OF INSTALLATION
1. Fix the under plate on the switch box by
screws(Local supply). In this case, fit the under
plate on the wall, and be careful of deformation.
2. Receive the remote control cord in the switch box.
3. Hook the remote control unit on the under plate.
Face of wall
Upper notch
Under plate
Remote
control unit
Screw
(Local supply)
Remote
control cord
Lower notch
Switch box
(Local supply)
ROUTING OF THE REMOTE CONTROL CORD
Be sure to connect
(Main board)
the wires to CN REMO
CN REMO
Brown
Red
Yellow
The maximum length of the cord is 70m.
WHEN THE REMOTE CONTROLLER IS
INSTALLED WITH THE CORD EXPOSED.
PROCEDURE OF INSTALLATION
Front case
1. Fix the under plate on the wall by self tapping
screws (accessory).
2. Make a slit (Part A) at the top side of the remote
control body by nipper.
Remote
controller
3.Rout the cord as shown in the following figure. In
body
this case, push the cord into the grooved around
the case(Part B).
4. Hook the remote control unit on the under plate.
FIXING OF REMOTE
CONTROL CORD
1. Fix the cord clamps on the wall
2. Fix the remote control cord.
9
• Keep the remote control cord away from the
refrigerant piping and the drain piping.
• To protect the remote control cord from
electrical noise, place the cord at least 5cm
away from other power cables. (Audio
equipment, Television set, etc)
• If the remote control cord is secured to a wall,
provide a trap at the top of the cord to
prevent water droplets from running.
Make sure that wire color
and indicated color at label
are matched on unit side
and remote controller side.
2
.
Face of wall
Upper notch
Remote
Under plate
control cord
Tapping screw
(Part A)
(Accessory)
Upper flange
Push hand
(Part B)
Remote
Lower notch
control unit
by ø3 tapping screws(Local supply).
Cord
clamp