Check The Loading Status; Seal The Case; Install The Special Balance Weight - Olympus PT-030 Manual De Instrucciones

Check the loading status.

Always perform the following final checks before sealing the Case.
Has the digital camera been loaded so that the zoom lever operates
properly?
Has the silica gel been inserted all the way at the specified position?
Are the O-ring and the O-ring contact surface free of dirt and other
foreign matter?
Is the O-ring installed properly both on the front and rear lids?
Is the TTL cable connector cap attached securely?

Seal the Case.

When the rear lid is closed
(quietly, so that the O-ring
will not come out of the
groove), the buckles are
engaged with the edge of
the rear lid, and the buckle
lock levers are pushed down
in arrow direction, the Case
will be sealed airtight.
CAUTION
: • Seal the Case by turning both buckle lock levers down in
arrow direction. When one of the buckles is left open, the
Case will not be sealed and water leakage will be caused.

Install the special balance weight.

Install the special balance
weight to the tripod
mounting thread at the
bottom of the Case.
Install the balance weight
securely by tightening the
accessory screw of the
balance weight.
E-21