Service Information; Troubleshooting - Black+Decker PP610 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Follow instructions for lubricating and changing accessories.
• Inspect appliance cord periodically, and if damaged, have it
repaired by an authorized service facility.
• Inspect extension cords periodically and replace if damaged.
• Keep handles dry, clean, and free from oil and grease.
Use only mild soap and damp cloth to clean the tool. Never let any
liquid get inside the tool; never immerse any part of the tool into a liquid.
ImpORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed by
authorized service centers or other qualified service organizations,
always using identical replacement parts.

SERvICE INFORmATION

All Black+Decker Service Centers are staffed with trained personnel
to provide customers with efficient and reliable power tool service.
Whether you need technical advice, repair, or genuine factory
replacement parts, contact the Black+Decker location nearest you.
To find your local service location, refer to the yellow page directory
under "Tools—Electric" or call: 1-800-544-6986 or visit www.
blackanddecker.com.
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or

TROUBLEShOOTING

If your Pole Saw does not operate correctly check the following:
Problem
possible Cause
• Tool will not
• Fuse blown or
start.
breaker tripped.
• Extension cord not
plugged in.
• Chain too tight.
• Bar / chain
overheated.
• Lubrication
needed.
• Chain is loose.
• Chain tension set
incorrectly.
• Chain tension set
• Poor cut quality
incorrectly.
• Chain needs
replacement.
• Unit runs but
• Chain installed
does not cut.
backwards. See
illustration B.
• Chain installed?
For assistance with your product, visit our website
www.blackanddecker.com for the location of the service center
nearest you or call the BLACK+DECKER help line at 1-800-544-6986
12
possible Solution
• Check fuse or breaker.
• Check to make sure
extension cord is plugged
into a working outlet.
• Refer to section on
adjusting chain tension.
• Refer to sections for chain
oiling application.
• Refer to section for chain
tensioning.
• Refer to section on
adjusting chain tension.
Note: Excessive tension
leads to excessive wear
and reduction in life of bar
& chain.
• Refer to section for
installation of chain.
• Refer to sections for
installing and removing
chain.

Publicidad

Tabla de contenido
loading

Tabla de contenido