Black+Decker PP610 Manual De Instrucciones página 4

REpLACEmENT pARTS: When servicing all tools, USE IDENTICAL
REpLACEmENT pARTS. Repair or replace damaged cords.
polarized plugs
To reduce the risk of electric shock, this appliance has a polarized
plug (one blade is wider than the other) and will require the use of a
polarized extension cord. The pole saw plug will fit into a polarized
extension cord only one way. If the plug does not fit fully into the
extension cord, reverse the plug. If the plug still does not fit, obtain a
correct polarized extension cord. A polarized extension cord will require
the use of a polarized wall outlet. This plug will fit into the polarized
wall outlet only one way. If the plug does not fit fully into the wall
outlet, reverse the plug. If the plug still does not fit, contact a qualified
electrician to install the proper wall outlet. Do not change the equipment
plug, extension cord receptacle, or extension cord plug in any way.
Before Operating pole Saw
• For safe operation, read and understand all instructions before using
the pole Saw. Follow all safety instructions. Failure to follow all safety
instructions listed below, can result in serious personal injury.
• Watch what you are doing. Use common sense. Do not operate Pole
Saw when you are tired.
• Use Pole Saw for cutting tree branches only. Do not use Pole Saw for
purposes not intended. Do not use for cutting other items.
• Only well-instructed adults should operate Pole Saw. Never allow
children to operate.
• Do not allow children or untrained individuals to use this unit.
• Wear the following safety gear when operating Pole Saw:
- heavy-duty gloves
- steel-toed safety footwear with non-skid soles
- safety glasses, goggles or face screen that are marked to
comply with ANSI Z87
- safety hard hat
- ear mufflers or ear plug
- face or dust mask (if working in dusty areas)
• Wear heavy long pants and boots. Do not wear loose fitting
clothing, short pants, jewelry of any kind, or go barefoot.
• Secure long hair so it is above shoulder level to prevent entanglement
in any moving parts.
• Before cutting, always provide the following:
- clear work area
- secure footing
- planned retreat path from falling limbs
• Inspect tree before trimming. Make allowance for branches to fall
freely to the ground.
• Do not use your Pole Saw to fell saplings.
While Operating pole Saw
DANGER:
To reduce the risk of electric shock do no use on
wet surfaces. Do not expose to rain. Store indoors.
DANGER:
Avoid Unintentional Starting – Don't carry plugged-in
appliance with finger on switch. Be sure switch is off when plugging in.
• Stay alert. Use common sense while operating the unit.
• Keep work area clean. Cluttered areas invite injuries.
• Always unplug pole saw when finished cutting or when left unattended.
• Keep children, animals and bystanders at least 50 ft. (15 m) away
from Pole Saw. Only Pole Saw user should be in work area.
• Do not use the Pole Saw to cut down trees.
• Do not grasp the exposed saw chain when picking up or holding
the pole saw.
• Grip Pole Saw securely - one hand on the pole, the other on the handle.
• Keep finger off trigger until ready to make cut.
• Before starting Pole Saw, make sure chain is not touching anything.
• Keep all parts of body away from chain when Pole Saw is running.
• Do not force Pole Saw while cutting. Apply light pressure. It will do the
job better and safer at the rate for which it was intended.
• Carry Pole Saw from one place to another
- with cord removed
- fingers off/away from trigger
- by holding pole at balance point
- with guide bar and chain to rear and with scabbard attached
• Do not cut small brush and saplings with the Pole Saw. Slender matter
may catch in the chain and be whipped toward you. This could also
pull you off balance.
• Do not operate in poor lighting.
• Keep firm footing and balance. Do not overreach. Overreaching can
result in loss of balance or exposure to hot surfaces.
• Keep all parts of your body away from any moving part.
• Do not, under any circumstance, use any attachment or accessory on
this product, which was not provided with the product, or identified as
appropriate for use with this product in this Instruction Manual.
4