Best UP26M Serie Manual De Instrucciones página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7. INSTALL THE ADAPTER/DAMPER (P3, P6
Attach 8" round adapter/damper to blower rough-in plate.
Use metal duct tape to make all joints secure and air-tight.
8. INSTALL THE ROUGH-IN PLATE (A
INTERIOR BLOWER: Secure the rough-in plate (provided with the
blower) inside the hood with four lock nuts. See
picture at right.
EXTERIOR OR IN-LINE BLOWER: Refer to instructions included with
9. INSTALL THE DEVIATOR (P5
YOU MUST install the deviator if you choose to vent the hood vertically. Install the deviator as
shown.
NOTE: If installed correctly, the deviator will protrude about 1/8" above the rough-in plate.
10. INSTALL THE ADAPTER (P5
Using provided screws, secure the adapter to the top (or back) of the hood. Seal the adapter to the hood using metal foil duct tape.
NOTE: For vertical exhaust, ensure that the damper pivot is located towards the front of the hood.
HD0005
LL BLOWERS
exterior or in-line blower rough-in kit.
Secure the rough-in plate inside the
hood with four lock nuts.
P8
AND
BLOWERS
P8
AND
BLOWERS ONLY
Q6
AND I
BLOWERS ONLY
HO0196
)
B
LOWER PLATE
HD0048
,
VERTICAL INSTALLATION ONLY
)
HD0006
8
)
L
OCK NUTS
)
HD0003
Inserting deviator into hood vertical opening.

Publicidad

Tabla de contenido
loading

Tabla de contenido