Safety Messages to Installers and Users
It is important to follow all instructions shipped with this product.
This sounder is to be installed by a trained electrician who is
thoroughly familiar with and will follow all applicable national and
local codes in the country of use.
This sounder should be considered a part of the warning system and
not the entire warning system.
The selection of the mounting location for the sounder, its controls
and the routing of the wiring are to be accomplished under the
direction of the facilities engineer and the safety engineer. In addition,
listed below are some other important safety instructions and
precautions you should follow:
•
Read and understand all instructions before installing or operating
this equipment.
•
To avoid electrical shock hazards, do not connect wires when
power is applied. Failure to observe this warning may lead to
serious injury or death.
•
Never alter the unit in any manner. Safety in hazardous locations
may be endangered if additional openings or other alterations are
made in units specifically designed for use in these locations.
•
Do not connect this sounder to the system when power is on.
•
All effective warning sounders produce loud sounds, which
may cause, in certain situations, permanent hearing loss. Take
appropriate precautions such as hearing protection. The device
should be installed far enough away from potential listeners to
limit their exposure while still maintaining its effectiveness.
•
After installation, ensure that all threaded joints are properly
tightened.
•
After installation, test the sounder system to ensure that it is
operating properly
Installation and Maintenance Instructions
Model G-SND Global Series Sounder
5