geberit RE 1 Instrucciones De Servicio página 18

Operation
18
Operating instructions pipe deburrer RE 1
Deburring
Prerequisites
• The workpiece is secured with a clamp or vice.
• The protective sphere is on the milling cutter.
DANGER
Risk of injury and fire hazard due to flying chips and
sparks
` Turn the protection device in the operating direction
before starting work
` Wear personal protective equipment and protective
goggles
` Only carry out work when no other people are in the
danger area (vicinity of 10 m)
` Remove explosive, combustible and heat-sensitive
materials from the working area or protect them from
flying sparks
` In buildings that can fall victim to fire, observe the fire
and police regulations and ensure that there is a fire
watch on duty after work
The electronics regulate the speed as the load increases.
In the event of extreme electromagnetic interference from
outside, temporary fluctuations in speed can occur.
Hold the pipe deburrer tight directly behind the protection
1
device and hold it against the pipe
Switching on the pipe deburrer: Push the slide switch back
2
and press it down at the front to lock it
1
2