G Eneral Notes On Safety; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; D Eclaration Of Incorporation - SUHNER MACHINING BEX 8 Documentación Técnica

1. n
1.1 g
enerAl nOtes On sAfety
This operation manual is applicable for the machine BEX
8.
The machine may only be handled by personnel
who are qualified.
1.2 u
se Of the mAchine fOr purpOses fOr
which it is intended
The machine is designed for axial and/or radial machining
like milling, drilling, reverse drilling, boring, grinding, chip
breakage, countersinking, and reverse countersinking.
This machine is specifically ideal for plant construction.
1.3 i
ncOrrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 d
eclArAtiOn Of incOrpOrAtiOn
The manufacturer Otto Suhner AG of Industriestrasse 10,
CH-5242 Lupfig, hereby declares for the partly completed
machinery (see reverse side for type and serial no.) that
the following fundamental requirements of the Directive
2006/42/EC are applied and fulfilled in accordance with
Annex I: 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7, 1.3.8.1, 1.5.1,
1.5.4, and 1.6.1. Technical documentation was generated
for the partly completed machinery in accordance with
Annex VII of the Machinery Directive. Document Agent:
I. Sebben. Authorised sites are provided with this techni-
cal documentation in paper or electronic form on justified
request. This partly completed machinery may be put into
operation only when the machine in which the partly com-
pleted machinery is to be incorporated has been ascer-
tained to fulfil the conditions under the Machinery Direc-
tive. CH-Lupfig, 09/2018.
I. Sebben/Division manager
2. c
2.1 A
ssemBly instructiOns
Maximum admissible machine fastening
error.
The machine may be clamped to the cy-
lindrical diameter (Ø70h7) only. The clamp must be de-
signed so that it does not deform the cylindrical diameter
(Ø70h7).
20
s
otEs on aFEty
ommissioning
Connect the cables only after the machine has
been completely installed.
2.1.1 f
Astening Of the mAchine On its mOunt
Correct lifting of machine with a crane.
2.2 c

Onnecting the pOwer tO the mAchine

2.2.1 d
escriptiOn Of the functiOn
A belt transfers the power delivered by the mounted brake
motor to the drive shaft. There a polygonal shaft transfers
the power to the spindle. The combination of belt pulleys
and therefore the spindle speed depend on the size of the
thread and the material. The feed speed of the full stroke
is defined by the speed of the spindle and the pitch of the
master screw.
2.2.2 m
OtOr
The bridges must be set on the terminal board be-
fore the motor is connected.