Usb Connection; Technical Data - Hilti SI­-AT­-A22 Manual De Instrucciones

Status
The LEDs show green.
The LEDs flash red.
The LEDs flash yellow.
3.6 Buzzer
The buzzer in the adaptive torque module emits the following signal tones as audible feedback:
• Long buzz: Confirmation signal (OK / operation completed successfully)
• 2 short buzzes, the LEDs flash yellow: Warning 1 (OK or, as applicable, not OK / repeat tightening)
• 4 short buzzes, the LEDs flash red: Warning 2 (not OK / operation aborted)
3.7

USB connection

The USB port can be used to connect the adaptive torque module to a PC. When this connection is made,
the AT Documentation Software offers a range of functions, including:
• Adding new data records for new fasteners
• Changing / updating existing data records
• Deactivating / activating the documentation function
• Loading the log from the documentation function
• Setting the clock in the torque module
Further information can be found in the documentation for the AT Documentation Software.
The software can be downloaded from here:
http://www.hilti.com/adaptive_torque_documentation_software
3.8 Items supplied
Adaptive torque module, operating instructions, quick-start guide, USB cable.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4

Technical data

Weight
Bar code scanner
4 English
Meaning
• When scanning: the barcode or QR code has
been recognized.
• When tightening, after the impact wrench
has switched off automatically: the tightening
operation was completed successfully.
• When scanning: the barcode or QR code was
not recognized.
• When tightening, after the impact wrench
switches off: The threaded fastener could not
be tightened in accordance with the selected
settings. The reason for this could be, for
example, that the impact wrench was switched
off manually before the correct torque was
achieved.
The module detected that the threaded fastener
had been tightened and subsequently slackened.
Consequently, the threaded fastener has been
retightened in accordance with defined parame-
ters for retightening, and the tightening operation
has been completed successfully.
0.57 lb
(0.26 kg)
Camera / scanner (imager)
2124681
*2124681*