Charging The Battery - Inficon D-TEK CO2 Manual Del Usuario

Charging the Battery

Connect the supplied AC wall charger or DC car charger to the D-TEK CO
jack and appropriate power source to charge the battery.
 While charging, the Charge indicator will flash
Allow at least 10 hours to fully charge the battery

 The Charge indicator will illuminate when the battery is fully charged or after
12 hours of charging
 Low battery is indicated by the green power indicator flashing
 When the battery is fully depleted, D-TEK CO
power indicator, the last yellow leak indicator, and the Charge indicator will
flash
NOTE: You should expect approximately 6½ hours of operation from a fully
charged battery. Connect D-TEK CO
check while charging the battery. The battery does not need to be fully
charged to operate or fully depleted to charge.
NOTE: If the power indicator, HI, and LO indicators alternate flashing while the
wall charger is connected, the battery may be unplugged or the connector
is backwards. This could also indicate a faulty battery.
W A R N I N G
Only use car or wall chargers supplied by INFICON and designed
for D-TEK CO
Using Your INFICON D-TEK CO
W A R N I N G
DO NOT OPERATE THIS INSTRUMENT IN THE PRESENCE OF
GASOLINE, NATURAL GAS, PROPANE, OR OTHER COMBUSTIVE
ATMOSPHERES.
Using D-TEK CO
2
The green power indicator will illuminate, and the yellow leak indicators will
illuminate from left to right in a scrolling fashion while the infrared cell warms up
(approximately 60 seconds). When the detector is ready for use, the yellow leak
indicators will extinguish and a steady beeping will begin. Long press the Power
button to turn D-TEK CO
. Using other chargers may damage the instrument.
2
is simple. Press the power button once to turn the detector ON.
OFF.
2
will turn OFF and the green
2
to the AC wall charger to leak
2
2
4
power
2