Honeywell Prestige THX9000 Guía De Instalación Del Sistema página 10

Prestige TM Installation Guide
Link remote control to thermostat (optional)
WIRELESS SETUP
Press to link to
another thermostat
YES
CONNECT MORE?
Link outdoor sensor to thermostat (optional)
Press and release
69-2445EFS—01
CONNECT
M28481
Press to save
and exit
NO
M28482
1 Make sure the thermostat displays
the "Add Device" timer screen (see
page 9).
2 Press CONNECT at the remote.
There will be a short delay as the
remote seeks a signal from the
thermostat.
3 When the screen displays
"Connected," press DONE.
4 Press NO at the next screen to save
and exit. (Or press YES and repeat
steps 1-4 to link another thermostat.)
The linking procedure at the remote may
time out if there is no keypress within 30
minutes. To begin again, press and hold the
blank space (or arrow, if present) in the lower
right corner of the screen until the display
changes (about 3 seconds).
1 Make sure the thermostat displays
the "Add Device" timer screen
(see page 9).
2 Press the CONNECT button on
the back of the sensor.
3 Check thermostat to verify that
the outdoor sensor is working.
After about 15 seconds, the
thermostat should display outdoor
temperature and humidity.
10