Celestron 47005 Manual De Instrucciones página 2

If the battery power becomes low on the Sensor, a "low battery icon" will appear on the LCD display
and change batteries to ensure a strong signal is being sent to the Receiver.
Settings and Operation of the Receiver
Time Zone – You can set an alternate time zone (during setup) for ±
12 hours. Once set you can access the alternate time by pressing for a
few seconds "- zone" button and doing the same to return to your
home time.
Moon Phase – will automatically be seen on the display and will be
correct if the calendar is set to the actual.
Max/Min Memory – in normal mode, press the button "min/max" to
see the maximum temperature and humidity both indoors and out,
press the button again to see the minimum temperature and humidity
both indoors and out, press the button again to return to the normal mode. The memory is
cleared once per day.
Barometer & Weather Forecast – the weather station has a built-in barometer to measure
atmospheric pressure
Cloudy/Cloudy/Rainy/Stormy. The unit predicts the weather conditions for
the next 12 to 24 hours based on the atmospheric pressure change and is
about 70% correct. The company accepts no liability for any incorrect
forecast. In normal mode press and hold down the "baro/down" button on
the back of the Receiver for a few seconds so you can set how you want to
view the atmospheric pressure readings – "in/Hg" or "mb/hPa" (hold the
button down again for a few seconds to change the setting). For the
barometer to be as accurate as possible the altitude must be set for your
location and you can find out your altitude from various local sources. Press
and hold the "baro/up" button down to select and then toggle between feet
and meters. To confirm feet or meters press the "hist" button. Then, press
the "baro/up" or "baro/down" buttons to set the altitude for your location.
The pressure tendency is shown in a small icon above the forecast –
rising/steady/falling.
Indoor & Outdoor Temperature & Humidity – the indoor
temperature and humidity is shown on the LCD display as is the
outdoor temperature and humidity. The outdoor temperature and
humidity trends will be displayed with a small icon to the right of
each display.
Data displayed in "C" or "F" – push the "- c/f" button (rear of
Receiver) when in a normal mode to change from "C" (Centigrade) or
"F" (Fahrenheit).
Clock & Calendar – Press the "set" button and hold down for a
couple of seconds to enter the setup mode. Use the "+" or "-" buttons
to make changes. Press "set" after each setting is correct. The settings in
sequence will be: year / month / date / hour / minute /12-24hr format /
time zone / exit. The day of the week is indicated near the time.
and forecasts the
2
weather with icons for Sunny/Partly