Arm; Disarm - Smanos WK7000 Manual De Usuario

EN

Arm

Input user code or admin code, and press
indicator flashes once and the keypad beeps once and sends
command to the control panel.
When the alarm panel receives the signal, the siren will beep once
and the [Arm] indicator will light on. The alarm system enters armed
state.
If there is an intrusion, the alarm system will be triggered, the
siren will hoot and the control panel will send SMS and auto dial
to pre-stored phone numbers to notify users. (SMS notification is
applicable only for GSM alarm systems.)

Disarm

Users can disarm alarm system by using keypad or by using RFID
tags.
Using Keypad to Disarm
Input user code or admin code, and press
indicator flashes once and the keypad beeps once and sends
[Disarm] command to the control panel.
21
[Arm] key, the LED
[Arm]
[Disarm] key, the LED
When the alarm panel receives the signal, the siren will beep twice
and the Disarm indicator will light on, the alarm system enters
disarmed state. In this state, the sensors being triggered will not
cause an alarm.
Using RFID Tag to Disarm
If direct disarm by RFID tag is disabled, user needs to press
wake up the keypad and then put RFID tag close to the reader to
disarm and unlock the door.
If direct disarm by RFID tag is enable, user can put RFID tag close to
the reader to disarm and unlock the door directly.
EN
[*] to
22