Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2. Press, one beep is heard a
enters learning state.
3. Put RFID tag close to the RFID reader, the connection succeeds after
one beep and the LED indicator goes out.
If two beeps are heard, it indicates the RFID tag has been connected
before.
To clear the connection of RFID tags, input
wake up the keypad and then press down
tags are all cleared after one beep..
7
[9]
nd the LED indicator is on. Keypad
[admin code]
+
[#]
[9]
for six seconds. RFID
Connect Electric Door Lock
To know connection steps, please refer to the instruction manual of
electric door lock.
Installation
Fix the keypad on the wall before use.
Loose the screw, open the case
①
Fix the rear cover on the wall by screws
②
Fasten the front cover of keypad on the rear cover. Secure two
③
covers into place and then screw on
Note:
Opening the rear cover of keypad will trigger tamper switch, please
to
disarm the alarm by following the disarm instruction in page 21-22.
EN
8
Publicidad
Capítulos
Tabla de contenido
